N94TA Bell 206-LIII accident

NTSB ANC97LA115 · 1997-08-01 · WASILLA, AK

Docket — crew, injuries and powerplant

Summary

The pilot was receiving an evaluation flight from a U.S. Department of Interior, Office of Aircraft Services, helicopter specialist. The intent of the flight was to certify the pilot to fly future government contracted flights. The helicopter pilot performed several maneuvers during the evaluation, and then landed on the shore of a small lake to re-hook an external bucket to the bottom of the helicopter. The terrain was level, but was in an area of soft marshy type tundra. The helicopter was equipped with full length flat skis attached to the bottom of the landing gear skid tubes. These tundra skis help prevent the helicopter skid tubes from sinking into soft terrain. After the external bucket's cable was attached to the helicopter, the pilot began to lift the helicopter into a hover. During the liftoff, the left skid tube remained stuck to the ground. The helicopter then rolled onto its left side and received damage to the fuselage and rotor system.

Full narrative

On August 1, 1997, about 1535 Alaska daylight time, a high skid equipped Bell 206-LIII helicopter, N94TA, crashed during takeoff from a remote lake, about 4 miles west of Wasilla, Alaska. The helicopter was being operated as a visual flight rules (VFR) local area evaluation ride under Title 14 CFR Part 91 when the accident occurred. The helicopter, registered to and operated by Trans-Alaska Helicopters Inc., Anchorage, Alaska, sustained substantial damage. The certificated commercial pilot was not injured. The evaluation pilot received minor injuries. Visual meteorological conditions prevailed. VFR company flight following procedures were in effect. The flight originated at the Big Lake Airport, Big Lake, Alaska, about 1400.

The operator reported the pilot was receiving an evaluation flight from a U.S. Department of Interior, Office of Aircraft Services, helicopter specialist. The intent of the flight was to certify the pilot to fly future government contracted flights. The helicopter pilot performed several maneuvers during the evaluation, and then landed on the shore of a small lake to re-hook an external bucket to the bottom of the helicopter. The terrain was level, but was in an area of soft, marshy type tundra. The helicopter was equipped with full length, flat skis attached to the bottom of the landing gear skid tubes. These tundra skis help prevent the helicopter skid tubes from sinking into soft terrain. After the external bucket's cable was attached to the helicopter, the pilot began to lift the helicopter into a hover. During the liftoff, the left skid tube remained stuck to the ground. The helicopter then rolled onto its left side and received damage to the fuselage and rotor system.

Probable cause

The pilot's inadvertent dynamic rollover during liftoff. Factors associated with the accident were soft terrain and a snagged landing gear skid. The National Transportation Safety Board determined the probable cause of this accident.

Circumstances

Event type
Accident
Highest injury
Minor
Weather conditions
Visual Meteorological Cond
Light condition
Day
Sky condition
NONE
Ceiling (ft)
0
Visibility (sm)
30
Wind direction
225
Wind speed (kt)
5
Temperature (F)
75
Distance from field
0.0

Aircraft

RegistrationMakeModelDamageFAR part
N94TA Bell 206-LIII SUBS 091

Sequence of events

#OccurrencePhase
1 380 Cruise

Findings

Finding
19200 factor
10417 factor
24801 cause