N22RM Miller S-1 accident

NTSB LAX97LA271 · 1997-08-04 · COTTONWOOD, AZ · near P-52

Docket — crew, injuries and powerplant

Summary

The pilot departed the morning of the accident to get the feel of the airplane. He was coming in for his fourth touchdown when he said he came in too fast and rolled out too far. He stated the left brake did not respond. A postaccident examination of the aircraft was conducted by an FAA airworthiness inspector. He reported that the aircraft design had several deficiencies. The rudder was very small and the 2-inch tail wheel horn was short. The wheels and brakes were from a Honda motorcycle, which was originally designed for a 200 pound motorcycle. This aircraft weighs approximately 1,200 pounds. The pilot had 2 hours of flight time in this airplane prior to the accident flight. There were no preimpact failures noted on the wheels and brakes.

Full narrative

On August 4, 1997, at 0850 hours mountain standard time, a Miller S-1, N22RM, ground looped during landing at Cottonwood, Arizona. The aircraft sustained substantial damage and the commercial pilot was not injured. The airplane was operated as a personal flight under 14 CFR Part 91 when the accident occurred. The flight originated at Montezuma Airport, Camp Verde, Arizona, at 0830. Visual meteorological conditions prevailed at the time of the accident.

According to the information provided in his report, the pilot had 2 hours in this particular aircraft. The pilot stated that he took off the morning of the accident flight to "get the feel of the aircraft and how it controlled and reacted." When he landed during his fourth touchdown, he said he "came in a little too fast and the roll out was too far." He stated that the right brake responded but that the left brake did not respond. The airplane went off the right side of runway 32 and came to rest at a 90-degree angle to the runway.

An FAA airworthiness inspector from the Scottsdale, Arizona, Flight Standards District Office examined the aircraft. He reported that the aircraft design had several deficiencies. He found that the rudder was too small for this aircraft and stated that the rudder would have no steering effect while the tail wheel was on the ground. Additionally, he stated that the tail wheel horn arm was minimal and would be very unresponsive considering the 2-inch diameter size of the tail wheel. He also reported that the main wheels and brakes are from a Honda "50" motorcycle. The original motorcycle design was intended to support a 200-pound vehicle. The aircraft is approximately 1,200 pounds. The inspector could not find any evidence of preimpact failure or malfunction with the landing gear or brake systems.

Probable cause

The inadequate strength and braking capability of the landing gear and wheel brakes, and the builder's attempt to adapt motorcycle parts to an aircraft application. A factor in this accident was the pilot's lack of familiarity with this experimental aircraft. The National Transportation Safety Board determined the probable cause of this accident.

Circumstances

Event type
Accident
Highest injury
None
Weather conditions
Visual Meteorological Cond
Light condition
Day
Sky condition
BKN
Ceiling (ft)
5000
Visibility (sm)
10
Wind direction
80
Wind speed (kt)
5
Temperature (F)
64
Nearest airport
COTTONWOOD
Distance from field
0.0
Airport elevation
3550

Aircraft

RegistrationMakeModelDamageFAR part
N22RM Miller S-1 SUBS 091

Sequence of events

#OccurrencePhase
1 260 Cruise
2 320 Cruise

Findings

Finding
10313 cause
10409 cause
10401 cause
10418 cause
10418 cause
24111 cause
24539
24537
82100 cause
34333 factor