N2355H Piper PA-18 accident

NTSB ANC97TA152 · 1997-09-18 · COLDFOOT, AK · near CXF

Docket — crew, injuries and powerplant

Summary

The airplane had just received a 100-hour inspection from a contract maintenance facility. The pilot was landing the tundra tire, tailwheel-equipped airplane on a gravel runway. During the flight, the pilot utilized a short section of tubing to direct heater air at his feet. During the landing touchdown, the pilot discovered the brakes were locked. The tires skidded on the gravel surface of the runway and the left wing struck the ground. The pilot indicated the brakes remained locked for about 2 hours after the accident. At that time, the wheels turned normally. The airplane utilizes a separate master brake cylinder/brake pedal assembly for each main wheel brake. The master cylinder/brake pedals are located on the cockpit floor, adjacent to the rudder pedals. The brake cylinders are normally serviced by adding hydraulic brake fluid through a small cap on the top of each cylinder. Maintenance personnel from the operator reported that overservicing of the brake cylinders, and heating of the cylinder assembly produced a locked brake condition.

Full narrative

On September 18, 1997, about 1330 Alaska daylight time, a tundra tire equipped Piper PA-18, N2355H, crashed during landing at the Coldfoot Airport, Coldfoot, Alaska. The airplane was being operated as a visual flight rules (VFR) cross-country government flight under Title 14 CFR Part 91 when the accident occurred. The airplane, operated by the State of Alaska, Department of Public Safety, Division of Fish and Wildlife Protection, sustained substantial damage. The certificated private pilot, the sole occupant, was not injured. Visual meteorological conditions prevailed. VFR flight following procedures were in effect. The flight originated at the Fairbanks International Airport, Fairbanks, Alaska, about 1030.

The operator reported the airplane had just received a 100 hour inspection from a contract maintenance facility in Fairbanks, Alaska, and the pilot was returning to his post in Coldfoot. During the flight, the pilot utilized a short section of tubing to direct heater air to his feet. The pilot landed on runway 19 at Coldfoot. When the airplane touched down, the pilot discovered the brakes were locked. The tires skidded on the gravel surface of the runway, and the left wing struck the ground. The pilot indicated the brakes remained locked for about 2 hours after the accident. At that time, the wheels turned normally.

The airplane manufacturer reported the airplane utilizes a separate master brake cylinder/brake pedal assembly for each main wheel brake. The master cylinder/brake pedals are located on the cockpit floor, adjacent to the rudder pedals. The brake cylinders are normally serviced by adding hydraulic brake fluid through a small cap on the top of each cylinder.

Maintenance personnel from the operator reported that over-servicing of the brake cylinders, and heating of the cylinder assembly produced a locked brake condition.

Probable cause

The overservicing/pressurizing of the hydraulic brake system by maintenance personnel that locked the brake system and prevented directional control. The National Transportation Safety Board determined the probable cause of this accident.

Circumstances

Event type
Accident
Highest injury
None
Weather conditions
Visual Meteorological Cond
Light condition
Day
Sky condition
OVC
Ceiling (ft)
5000
Visibility (sm)
40
Wind direction
150
Wind speed (kt)
6
Temperature (F)
45
Nearest airport
COLDFOOT
Distance from field
0.0
Airport elevation
1050

Aircraft

RegistrationMakeModelDamageFAR part
N2355H Piper PA-18 SUBS 091

Sequence of events

#OccurrencePhase
1 260 Cruise

Findings

Finding
10418 cause
10418 cause
24105 cause
24539
24537