N2692D Cessna 170B accident

NTSB ANC98LA041 · 1998-04-25 · KENAI, AK

Docket — crew, injuries and powerplant

Summary

The pilot and a passenger were in cruise flight in a tailwheel equipped airplane. About one hour after departure, the engine oil pressure began to decrease to below the normal operating range. The pilot began a climb to 3,500 feet mean sea level. The engine then began to run rough, and the pilot shut the engine off. The pilot performed an emergency landing in a small open area that had previously been used as a landing area. The airplane touched down in snow covered terrain, and then nosed over. The airplane received damage to the left wing spar, the rudder, and the leading edge of both wings. An examination of the airplane engine revealed the number six piston connecting rod bearing, and the connecting rod cap, were destroyed. The number six crankshaft rod bearing journal was blackened and battered.

Full narrative

On April 24, 1998, about 2140 Alaska daylight time, a tundra tire equipped Cessna 170B airplane, N2692D, sustained substantial damage during a forced landing, about 44 miles west of Kenai, Alaska. The airplane was being operated as a visual flight rules (VFR) cross-country personal flight when the accident occurred. The airplane was registered to, and operated by the pilot. The certificated private pilot, and the sole passenger, were not injured. Visual meteorological conditions prevailed. The flight originated from a remote airstrip about 2040.

During a telephone conversation with the National Transportation Safety Board (NTSB) investigator-in-charge (IIC), on April 27, 1998, at 0800, the pilot reported he departed Keys Point at Lake Clark, Alaska, and was flying through Lake Clark Pass. While in cruise flight, the oil pressure began to decrease to below the normal operating range. The pilot began a climb to 3,500 feet mean sea level. The engine then began to run rough, and the pilot shut the engine off. He made an emergency landing in a small open area. The airplane touched down in snow covered terrain, and then nosed over. The airplane received damage to the left wing spar, the rudder, and the leading edge of both wings.

A Federal Aviation Administration (FAA) airworthiness inspector, Anchorage Flight Standards District Office (FSDO), Anchorage, Alaska, examined the airplane engine on April 29, 1998. The inspector reported the number six piston connecting rod bearing was destroyed. The connecting rod cap was also destroyed. The number six crankshaft rod bearing journal was blackened and battered.

The pilot reported the engine had accrued a total time of 4,417.28 hours. It had accrued 1,274.18 hours since an engine overhaul. The most recent inspection was an annual inspection conducted on November 28, 1997, 13.65 hours before the accident.

Probable cause

A failure of the number six cylinder rod bearing and connecting rod cap for undetermined reasons. Factors in the accident were snow covered terrain that was unsuitable for a forced landing. The National Transportation Safety Board determined the probable cause of this accident.

Circumstances

Event type
Accident
Highest injury
None
Weather conditions
Visual Meteorological Cond
Light condition
Day
Sky condition
NONE
Ceiling (ft)
0
Visibility (sm)
50
Wind direction
270
Wind speed (kt)
15
Temperature (F)
45
Distance from field
0.0

Aircraft

RegistrationMakeModelDamageFAR part
N2692D Cessna 170B SUBS 091

Sequence of events

#OccurrencePhase
1 351 Cruise
2 180 Cruise
3 320 Cruise
4 300 Cruise

Findings

Finding
14001 cause
14022 cause
25000
19200 factor
19200 factor