N591DC Cessna T210L accident

NTSB FTW98LA173 · 1998-04-05 · SANTA TERESA, NM

Docket — crew, injuries and powerplant

Summary

During a descent for landing with the power set at 23 inches of manifold pressure and 2,300 rpm, there was a loud noise, and something was observed to come out of the cowling. This was followed by a sudden loss of engine power, severe engine vibration, and light blue smoke in the cockpit. The pilots landed on a dirt road, but the airplane struck a sand dune, bounced, and nosed over. Postaccident engine examination disclosed the #1 piston had broken in half. The top half of the piston remained in the upper (outer) portion of the #1 cylinder. The bottom half of the piston was destroyed. The connecting rod and the cap bolt had separated. The camshaft and its splined end (where it attached to the oil pump) were damaged, and the oil pump had seized. There was 'necking down' of the rod cap bolts, consistent with tension overload. The engine had accrued 1,464.7 hours of flight time since new, and 915.1 hours of flight time since major overhaul.

Full narrative

On April 5, 1998, approximately 1000 mountain daylight time, a Cessna T210L, N591DC, was substantially damaged during a forced landing 4 miles south of Santa Teresa, New Mexico. The private certificated instrument rated pilot receiving instruction and the airline transport rated flight instructor received minor injuries. Visual meteorological conditions prevailed, and no flight plan was filed for the instructional flight being conducted under Title 14 CFR Part 91. The flight originated at Santa Teresa, New Mexico, approximately 0800.

According to the accident report submitted by the pilot, he was receiving an instrument competency check from the flight instructor. He and his instructor departed Santa Teresa, flew to Deming and Silver City, New Mexico, where instrument approaches were conducted. They were returning to Santa Teresa and were on an "extended let-down from 50 nm out at 23 inches of manifold pressure, 2,300 rpm, and 130 knots indicated airspeed." There was a loud noise, they caught a glimpse of something shoot out from the cowling, then there was a "sudden loss of power, severe engine vibration, and light blue smoke in the cockpit." The pilot landed on a dirt road 1.5 miles northwest of Santa Teresa, struck a sand dune, bounced, and nosed over.

The engine was examined on April 22, 1998, by an FAA inspector and a representative of the engine manufacturer. The no. 1 piston was broken in half. The top half remained inside the upper portion of the no. 1 cylinder. The bottom half was destroyed. The connecting rod and the cap bolt were separated. The camshaft and its splined end (where it attaches to the oil pump) were damaged, and the oil pump had seized. There was "necking down" of the rod cap bolts, consistent with tension overload.

According to the maintenance records, the engine was installed in a new airplane, N1788X, on March 28, 1975. The engine had accrued 549.6 total hours when it was removed from the airplane, overhauled, and installed in N591DC. At the time of the accident, the engine had accumulated 1,464.7 total hours, or 915.1 hours since major overhaul.

Probable cause

failure of the number 1 piston, which resulted in loss of engine power and a subsequent forced landing. The lack of suitable terrain for a forced landing was a related factor. The National Transportation Safety Board determined the probable cause of this accident.

Circumstances

Event type
Accident
Highest injury
Minor
Weather conditions
Visual Meteorological Cond
Light condition
Day
Sky condition
NONE
Ceiling (ft)
0
Visibility (sm)
10
Wind direction
250
Wind speed (kt)
4
Temperature (F)
63
Distance from field
0.0

Aircraft

RegistrationMakeModelDamageFAR part
N591DC Cessna T210L SUBS 091

Sequence of events

#OccurrencePhase
1 351 Cruise
2 180 Cruise
3 320 Cruise
4 300 Cruise

Findings

Finding
14008 cause
14006
14022
15204
19200 factor
19200 factor
19200 factor