N4561C Read ROTORWAY EXECUTIVE accident

NTSB CHI98LA152 · 1998-05-13 · VALPARAISO, IN · near VPZ

Docket — crew, injuries and powerplant

Summary

The pilot pushed the helicopter out of the hangar, preflighted it, started it, and warmed it up to operating minimums. He lifted off of the ground to an approximate height of 12 inches. That is when he heard a 'clunk' from behind him. The pilot said that he thought that something might have gone through the tail rotor, so he turned the helicopter to the left 180 degrees. Seeing nothing, the pilot decided to set down. At that point, the helicopter pitched over on it's right side. The pilot said that he 'neglected to remove the transport wheels' before flight. Examination of the helicopter revealed that both transport wheels were installed on the skids.

Full narrative

On May 13, 1998, at 1810 eastern standard time (est), a Read Rotorway Executive 90, homebuilt helicopter, N4561C, operated by a commercial pilot, sustained substantial damage when maneuvering during initial hover, the helicopter's right transport wheel and skid caught on the concrete ramp, at Porter County Municipal Airport, Valparaiso, Indiana. The helicopter subsequently rolled over and impacted on the ramp. Visual meteorological conditions prevailed at the time of the accident. The local, personal flight was being conducted under 14 CFR Part 91. The pilot reported no injuries.

In his written statement, the pilot said that he pushed the helicopter out of the hangar, preflighted it, started it, and warmed it up to operating minimums. "At light-on-the-skids point, all seemed fine." The pilot said that he lifted off of the ground to an approximate height of 12 inches. That is when he heard a "clunk" from behind him. The pilot said that he thought that something might have gone through the tail rotor, so he turned the helicopter to the left 180-degrees. Seeing nothing, the pilot decided to set down. At that point, the helicopter pitched over on it's right side. The pilot said that he "neglected to remove the transport wheels" before flight.

A Federal Aviation Administration (FAA) inspector examined the helicopter in the pilot's hangar at Porter County Municipal Airport. Both main rotor blades showed chordwise scratches at approximately mid-span. The outboard tips of both rotor blades were curled upward. The fuselage was bent upward and wrinkled. The cockpit windscreen was broken out. The cockpit interior remained intact. No damage was observed to the seats, control panel, or helicopter controls. The right fin on the tail boom was scraped. The left fin was broken off. The tail rotor showed no damage. The right transport wheel was attached to the right skid. The wheel was bent down and inward, and broken on the outboard side. The left transport wheel was attached to the left skid. The left transport wheel axle and fitting were bent downward approximately 45-degrees. Helicopter flight control continuity was confirmed. No anomalies were found in the engine, engine controls, or other helicopter systems.

Probable cause

the pilot not maintaining adequate clearance with the ground during hover. Factors which contributed to this accident were the pilot's execution of a hovering turn at too low of an altitude, inadequate preflight preparation, and failing to remove the transport wheels from the helicopter skids prior to flight. The National Transportation Safety Board determined the probable cause of this accident.

Circumstances

Event type
Accident
Highest injury
None
Weather conditions
Visual Meteorological Cond
Light condition
Day
Sky condition
NONE
Ceiling (ft)
0
Visibility (sm)
10
Wind direction
0
Wind speed (kt)
6
Temperature (F)
73
Nearest airport
PORTER COUNTY MUNICIPAL
Distance from field
0.0
Airport elevation
770

Aircraft

RegistrationMakeModelDamageFAR part
N4561C Read ROTORWAY EXECUTIVE SUBS 091

Sequence of events

#OccurrencePhase
1 160 Cruise
2 230 Cruise

Findings

Finding
10401 factor
24526 cause
24804 factor
24001 factor