N8399H North American AT-6G accident

NTSB FTW98LA298 · 1998-07-05 · LONGMONT, CO · near 2V2

Docket — crew, injuries and powerplant

Summary

The pilot was given airport advisories on unicom. He was told that the active runway was 29 and that the wind was 'light and variable.' He said that the 'windsock's movement was hardly perceptible and the velocity of the indicator indicated less than 5 knots.' The pilot reported that after touchdown, 'the aircraft's rollout path took multiple, short, quick inputs from the rudder to keep properly aligned with the runway centerline as the aircraft proceeded down the runway.' He further reported the rudder inputs became ineffective after approximately 400 to 500 feet of landing roll and the aircraft exited the right side of the runway. The aircraft subsequently impacted an airport taxiway sign, damaging the left main landing gear and the left wing. The aircraft came to rest with its nose down. The pilot said that the tail wheel steering cables had recently been replaced. Postaccident evaluation of the tail wheel steering cables by maintenance personnel found a tension of 5 pounds on these cables; 20 pounds is considered normal.

Full narrative

On July 5, 1998, approximately 1050 mountain daylight time, a North American AT-6G, N8399H, was substantially damaged when it departed the side of the runway while on landing roll at Vance Brand Municipal Airport, Longmont, Colorado. The airline transport rated pilot and his passenger were not injured. The airplane was being operated by the pilot under Title 14 CFR Part 91. Visual meteorological conditions prevailed for the cross-country flight which originated from Centennial Airport, Englewood, Colorado, approximately 50 minutes before the accident. No flight plan had been filed.

The pilot said he requested airport advisories on unicom and was told that the active runway was 29, and that the wind was "light and variable." The pilot stated that he flew over the field to position himself for traffic pattern entry, and observed that the "windsock's movement was hardly perceptible and the velocity of the indicator indicated less than 5 knots." The pilot reported that after touchdown, "the aircraft's rollout path took multiple, short, quick inputs from the rudder to keep properly aligned with the runway centerline as the aircraft proceeded down the runway." He further reported the rudder inputs became ineffective after approximately 400 to 500 feet of landing roll and the aircraft departed the right side of the runway. The aircraft subsequently impacted an airport taxiway sign, damaging the left main landing gear and the left wing. The aircraft came to rest on its nose.

The pilot reported to the Investigator-In-Charge that tail wheel steering cables had recently been replaced. Postaccident evaluation of the tail wheel steering cables by maintenance personnel found a tension of 5 pounds on these cables; 20 pounds is considered normal (see attached letter).

Probable cause

The partial failure of the tail wheel steering system due to improper maintenance and the subsequent inadvertent ground loop during the landing sequence. Factors were the airport taxiway sign and the subsequent failure of the left main landing gear. The National Transportation Safety Board determined the probable cause of this accident.

Circumstances

Event type
Accident
Highest injury
None
Weather conditions
Visual Meteorological Cond
Light condition
Day
Sky condition
NONE
Ceiling (ft)
0
Visibility (sm)
80
Wind direction
350
Wind speed (kt)
7
Temperature (F)
84
Nearest airport
VANCE BRAND AIRPORT
Distance from field
0.0
Airport elevation
5052

Aircraft

RegistrationMakeModelDamageFAR part
N8399H North American AT-6G SUBS 091

Sequence of events

#OccurrencePhase
1 260 Cruise
2 310 Cruise
3 290 Cruise

Findings

Finding
10425 cause
24537 cause
24107 cause
20200 factor
10401 factor