N1239Y Cessna 150B accident

NTSB CHI98LA326 · 1998-08-21 · LAMAR, MO · near LLU

Docket — crew, injuries and powerplant

Summary

The pilot said her landing in the tail wheel airplane was uneventful. During the landing roll, the airplane suddenly veered to the left while in a 3-point attitude. The pilot said right rudder did not stop the turn and the airplane ran off the runway edge and into a 4-foot deep ditch. The on-site investigation revealed that the left main landing gear's brake torque plate holes and torque pins were dry. The wheel would not rotate. According to the pilot, she had never experienced dragging brakes while flying the airplane.

Full narrative

On August 21, 1998, at 1545 central daylight time (cdt), a Cessna 150, N1239Y, piloted by a private pilot, was substantially damaged when it nosed over when it collided with a ditch shortly after departing the left edge of Runway 21 (2,905' X 40', dry asphalt) at the Lamar Municipal Airport, Lamar, Missouri. Visual meteorological conditions prevailed at the time of the accident. The 14 CFR Part 91 flight was not operating on a flight plan. The pilot reported no injuries. The flight departed Pittsburg, Kansas, 1515 cdt.

According to the pilot, the wind sock at the landing was "...limp." She said she landed the airplane in a 3-point attitude and was on an uneventful landing roll when the airplane suddenly veered to the left. She said right rudder correction did not stop the turn. The ditch N1239Y collided with was about 30-feet from the runway edge and about 4-feet deep.

According to the Federal Aviation Administration Principal Maintenance Inspector (PMI) who examined N1239Y, "...the [left main landing gear's brake] torque plate holes and torque pins were dry... ." The PMI said, "...a person who had assisted in the recovery of the airplane stated that after the airplane was [being] towed... he noted that the left main wheel would not rotate." The PMI said the dry torque plate and pins "...[have] been observed to cause locking of brake assemblies in this inspector's experience." Statements from the mechanic and PMI are appended to this report.

The PMI said lubrication of the torque plates and pins normally should take place during the annual inspection and whenever the brakes appear to drag during service. The pilot/owner said she had not experienced any dragging brakes during the time she flew the airplane.

Probable cause

inadequate lubrication of the torque plate holes and torque pins by the mechanic who performed the airplane's last annual inspection. The National Transportation Safety Board determined the probable cause of this accident.

Circumstances

Event type
Accident
Highest injury
None
Weather conditions
Visual Meteorological Cond
Light condition
Not Reported
Sky condition
NONE
Ceiling (ft)
0
Visibility (sm)
10
Wind direction
50
Wind speed (kt)
8
Temperature (F)
90
Nearest airport
LAMAR MUNICIPAL AIRPORT
Distance from field
0.0
Airport elevation
1009

Aircraft

RegistrationMakeModelDamageFAR part
N1239Y Cessna 150B SUBS 091

Sequence of events

#OccurrencePhase
1 130 Cruise
2 260 Cruise
3 320 Cruise

Findings

Finding
10418
24112 cause
24542
19200