N2099J Fennell VP2 accident

NTSB FTW98LA345 · 1998-08-06 · COLLINSVILLE, OK

Docket — crew, injuries and powerplant

Summary

After about 20 minutes of flight, and while setting up to enter a local landing pattern, the engine began to slowly loose power, and the engine 'quit.' Subsequently, the pilot maneuvered the aircraft toward an open field, and at about 20 to 25 feet AGL, initiated a 'power off' stall. Upon ground contact, the airplane veered about 180 degrees 'violently to the right.' Inspection of the airplane by an FAA inspector after the accident, revealed that a single set screw had been used to secure the throttle cable at the throttle arm. The screw was found to be 'loose' in the carburetor barrel and did not appear to be tight against the cable end. A similar wire cable end was easily pushed through the barrel, indicating that the throttle control cable may not have been securely fastened to the throttle arm prior to the accident.

Full narrative

On August 5, 1998, approximately 1900 central daylight time, a Fennell VP2 homebuilt experimental airplane, N2099J, was destroyed during a forced landing following a loss of engine power near Collinsville, Oklahoma. The private pilot, who was the sole occupant, received minor injuries. Visual meteorological conditions prevailed, and no flight plan was filed for the Title 14 CFR Part 91 personal flight. The local flight originated from a private grass airstrip about 20 minutes prior to the accident.

The 1,500 hour pilot stated that while setting up to enter a landing pattern at a private airstrip, the engine began to slowly loose power, and the engine "quit." Subsequently, he maneuvered the aircraft toward an open field, and at about 20 to 25 feet AGL, initiated a "power off" stall. Upon ground contact, the airplane veered about 180 degrees "violently to the right." With the exception of the floor-seat combination, everything forward of the aft spar bulkhead essentially disintegrated.

Inspection of the airplane by an FAA inspector after the accident, revealed that a single set screw had been used to secure the throttle cable at the throttle arm. The screw was found to be "loose" in the carburetor barrel and did not appear to be tight against the cable end. A similar wire cable end was easily pushed through the barrel, indicating that the throttle control cable may not have been securely fastened to the throttle arm prior to the accident.

The Volkswagen powered airplane had accumulated a total of 93 flight hours.

Probable cause

The loose throttle control cable resulting in the loss of engine power. A factor was the pilot's decision to intentionally stall the airplane close to the ground during the forced landing to an open field. The National Transportation Safety Board determined the probable cause of this accident.

Circumstances

Event type
Accident
Highest injury
Minor
Weather conditions
Visual Meteorological Cond
Light condition
Day
Sky condition
NONE
Ceiling (ft)
0
Visibility (sm)
10
Wind direction
320
Wind speed (kt)
6
Temperature (F)
81
Distance from field
0.0

Aircraft

RegistrationMakeModelDamageFAR part
N2099J Fennell VP2 DEST 091

Sequence of events

#OccurrencePhase
1 350 Cruise
2 180 Cruise

Findings

Finding
16004 cause
19200
24551 factor