N8252S Piper PA-28RT-201T accident

NTSB FTW98LA404 · 1998-09-18 · DUCK CREEK, UT

Docket — crew, injuries and powerplant

Summary

The airplane was in cruise flight at 12,500 feet when the pilot noticed the manifold pressure had dropped from 51.8 inches to 25 inches. 'The engine had poor response to throttle movement, and the engine sounded bad when I moved the throttle.' He made the decision not to proceed further due to the remote terrain. As he checked his maps for the nearest airport, the airplane lost altitude. 'The engine did not seem to have much power, and I was about 3,000 feet AGL by this time.' The pilot made a forced landing on a dirt road. During rollout the aircraft struck poles alongside of a cattle guard. According to the salvage company and the FAA inspector who examined the engine, two of the four screws securing the rocker cover on the number 3 cylinder were missing, and oil was leaking out. The rocker cover had a round indention on the outside, and a wear mark on the inside. The exhaust rocker arm studs were also loose. The rear stud was only finger tight. Aluminum was found imbedded in its threads. The front stud was loose, but its nut locking mechanism was still in place.

Full narrative

On September 18, 1998, approximately 1400 mountain daylight time, a Piper PA-28RT-201T, N8252S, was substantially damaged when it collided with poles during a forced landing near Duck Creek, Utah. The commercial pilot, the sole occupant aboard, was not injured. Visual meteorological conditions prevailed, and a VFR flight plan had been filed for the personal cross-country flight conducted under Title 14 CFR Part 91. The flight originated at Canyonlands Field, Moab, Utah, approximately 1300.

In his accident report, the pilot said he was in cruise flight at 12,500 feet, en route to Las Vegas, Nevada, when he noticed the manifold pressure had dropped from 51.8 inches to 25 inches. "The engine had poor response to throttle movement, and the engine sounded bad when I moved the throttle." The pilot made the decision not to proceed further due to the remote terrain. As he checked his maps for the nearest airport, the airplane lost altitude. The pilot said the "engine did not seem to have much power, and I was about 3,000 feet AGL by this time." The pilot made a forced landing on a dirt road. During the landing roll, the aircraft struck poles next to a cattle guard, causing substantial damage.

According to the salvage company and the FAA inspector who examined the engine, two of the four screws securing the rocker cover on the number 3 cylinder were missing, and oil was leaking out. The rocker cover had a round indention on the outside, and a wear mark on the inside. The exhaust rocker arm studs were also loose. The rear stud was only finger tight. Aluminum was found imbedded in its threads. The front stud was loose, but its nut locking mechanism was still in place.

Probable cause

Loose intake valve rocker arm studs that allowed a loss of compression and a loss of oil. A factor was unsuitable terrain on which to make a forced landing and poles next to a cattle guard. The National Transportation Safety Board determined the probable cause of this accident.

Circumstances

Event type
Accident
Highest injury
None
Weather conditions
Visual Meteorological Cond
Light condition
Day
Sky condition
NONE
Ceiling (ft)
0
Visibility (sm)
10
Wind direction
220
Wind speed (kt)
23
Temperature (F)
81
Distance from field
0.0

Aircraft

RegistrationMakeModelDamageFAR part
N8252S Piper PA-28RT-201T SUBS 091

Sequence of events

#OccurrencePhase
1 352 Cruise
2 180 Cruise
3 310 Cruise

Findings

Finding
14017 cause
17002 factor
14011 factor
19200 factor
20200 factor