N99924 Ercoupe (Eng & Research Corp.) 415-C accident

NTSB MIA99LA025 · 1998-10-31 · HARTSELLE, AL

Docket — crew, injuries and powerplant

Summary

The engine lost power as the pilot turned onto the downwind leg for landing. As the pilot approached a field for landing, the aircraft collided with a power line and then the ground. Postcrash examination of the engine showed it was operating with an excessive rich fuel mixture. The carburetor float was found stuck in the full needle valve open position due to excessive solder on the float fulcrum contacting the bowl wall. The carburetor had been recently modified by installing a new style needle valve, which also required the addition of weight to the float fulcrum with solder.

Full narrative

On October 31, 1998, about 1330 central standard time, an Ercoupe 415-C, N99924, registered to an individual, collided with a power line and crashed in a field while making a forced landing following loss of engine power at Hartselle, Alabama, while on a Title 14 CFR Part 91 personal flight. Visual meteorological conditions prevailed at the time and no flight plan was filed. The aircraft received substantial damage and the private-rated pilot received serious injuries. The flight originated from Roundtree Field, Hartselle, Alabama, about 1245.

The pilot stated this was the first flight since extensive repairs and restoration to the aircraft. After takeoff he departed the airport traffic pattern and climbed to 3,500 feet. He performed maneuvers for about 30 minutes and then returned to the airport traffic for takeoffs and landings. After the second landing, he again took off. As he turned onto the downwind leg, the engine quit without warning. A quick attempt to restart the engine was unsuccessful. He selected a landing site for a forced landing and turned toward it. He was unable to maintain sufficient altitude to clear a power line and the aircraft collided with it, causing the aircraft to nose down. The aircraft then impacted a ditch and bounced and landed on the landing gear, from which a normal landing roll was made.

Postcrash examination of the engine was performed by FAA inspectors. The spark plugs were found to have black soot deposits. The exhaust system also had black soot deposits. The engine was started and operated at idle power for a short time before quitting. A higher engine power was not attempted due to a fuel leak from fuel line damage during ground impact.

The Bendix-Stromberg float carburetor was removed from the engine by FAA inspectors and taken to an overhaul facility. The float was found stuck in the full needle valve open position. Excessive solder on the float fulcrum was contacting the edge of the bowl causing it to stick. The carburetor had been modified in accordance with Bendix-Stromberg Service Bulletin 84 which calls for installation of a new style needle valve which in turn calls for adding of solder weight to the float fulcrum. The service bulletin warns that the added weight should not interfere with the movement of the float. (See attached FAA inspector report)

Probable cause

Improper modification of the carburetor float by maintenance personnel resulting in the float sticking in the full needle valve open position and failure of the engine due to excessive fuel flow. The National Transportation Safety Board determined the probable cause of this accident.

Circumstances

Event type
Accident
Highest injury
Serious
Weather conditions
Visual Meteorological Cond
Light condition
Day
Sky condition
NONE
Ceiling (ft)
0
Visibility (sm)
10
Wind direction
350
Wind speed (kt)
7
Temperature (F)
79
Distance from field
0.0

Aircraft

RegistrationMakeModelDamageFAR part
N99924 Ercoupe (Eng & Research Corp.) 415-C SUBS 091

Sequence of events

#OccurrencePhase
1 351 Cruise
2 180 Cruise
3 220 Cruise
4 230 Cruise

Findings

Finding
15126
17001
24113 cause
20200
19200