N2313L Beech C23 accident

NTSB LAX99LA062 · 1998-12-31 · FURNACE CREEK, CA · near L06

Docket — crew, injuries and powerplant

Summary

The private pilot/ owner and his daughter had arrived at Furnace Creek after departing Lancaster earlier that morning. They toured Death Valley National Park for several hours and were preparing to return home. The pilot conducted his preflight check in the tie down area. After back taxiing on the runway and aligning the aircraft for takeoff, he became concerned that he would not be able to see approaching aircraft while he conducted his takeoff checklist. He decided to maintain his position but would expedite without using the written checklist from the glove compartment. He performed his run-up and completed the checks from memory. He announced his departure on Unicom, added full power, and began the takeoff roll. He estimated rotation speed (65 mph) was reached approximately 2/3 of the way down the runway. As he started to pull on the control yoke, he realized the gust lock pin was still in the locked position. He felt that he could not abort the takeoff at this point without departing the end of the runway at a high rate of speed. He attempted to remove the gust lock, which required him to depress a button on the bottom of the pin while pulling down on the shaft. As he was struggling with the pin, the aircraft overran the runway. The nose gear dug into the dirt and was sheared off. He estimated the aircraft came to rest 30-50 yards past the end of the runway. As he secured the cockpit the pilot noticed the key was sheared off, the throttle was pulled out and the shaft was bent down. He also noted that the control lock was on the floor with a broken piece of its neoprene housing. The pilot exited the aircraft behind his daughter.

Full narrative

On December 30, 1998, about 1630 hours Pacific standard time, a Beech C23, N2313L, sustained substantial damage when it collided with terrain during a takeoff overrun from the Furnace Creek, California, airport. The private pilot/owner and his passenger both received minor injuries. The aircraft departed Lancaster, California, at 1000 for the flight to Furnace Creek. The personal flight was conducted under the provisions of 14 CFR Part 91. After touring Death Valley National Park, the pilot/owner and his daughter were departing for Lancaster when the accident occurred. Visual meteorological conditions prevailed and no flight plan was filed.

The pilot stated he performed his preflight in the tie down area. There was no wind so he elected to use runway 15. After checking visually and with Unicom, the pilot proceeded to back taxi on the runway to the departure end since Furnace Creek has no taxiway. He lined up in position for takeoff to conduct his takeoff checklist. He stated he became concerned that he could not see approaching traffic while he was pointed in this direction and considered repositioning so that he could. He maintained this position but decided to forego pulling the written checklist from the glove compartment and did the checklist by memory. After completing his run-up and checks, he announced his departure on Unicom, added full power, and began the takeoff roll. He estimated rotation speed (65 mph) was reached approximately 2/3 of the way down the runway. As he started to pull on the control yoke, he realized the gust lock pin was still in the locked position. He felt that he could not abort the takeoff at this point without departing the end of the runway at a high rate of speed. He attempted to remove the gust lock, which required him to depress a button on the bottom of the pin while pulling down on the shaft. As he was struggling with the pin, the aircraft overran the runway. The nose gear dug into the dirt and was sheared off. He estimated the aircraft came to rest 30-50 yards past the end of the runway. The pilot turned off the magnetos and fuel. He noticed that the key was sheared off and that the throttle was pulled out and bent down sharply. Lying on the floor was the gust lock pin and a broken part of its neoprene housing. Fuel was flowing down the right wing as the pilot followed his daughter out of the aircraft.

Probable cause

The pilot's inadequate preflight inspection when he failed to remove the gust lock from the flight controls. The National Transportation Safety Board determined the probable cause of this accident.

Circumstances

Event type
Accident
Highest injury
Minor
Weather conditions
Visual Meteorological Cond
Light condition
Day
Sky condition
NONE
Ceiling (ft)
0
Visibility (sm)
50
Wind direction
0
Temperature (F)
64
Nearest airport
FURNACE CREEK
Distance from field
0.0
Airport elevation
0

Aircraft

RegistrationMakeModelDamageFAR part
N2313L Beech C23 SUBS 091

Sequence of events

#OccurrencePhase
1 260 Cruise
2 340 Cruise
3 320 Cruise

Findings

Finding
10329 cause
24002 cause
24505 factor
10405