N8235W Adams ROTORWAY EXEC-90 accident

NTSB NYC99LA148 · 1999-06-13 · EVINGTON, VA

Docket — crew, injuries and powerplant

Summary

The pilot was approaching to land in his homebuilt helicopter. He was applying maximum power, but did not have sufficient rotor RPM. In an attempt to increase RPM, he lowered the collective, causing the helicopter to undershoot the intended landing point. The pilot could not touchdown at this point, because the field was at a 9 to 10 degree slope angle. Additionally, he did not have enough rotor RPM to hover up-slope. He made a 180 degree turn and flew down-slope. After the turn, the forward momentum plus the 1 to 2 knot headwind slightly increased rotor RPM. However, the pilot still did not have enough power to hover. He decided to perform a slide-on landing. During the landing, the right skid struck a mound of dirt, causing the helicopter to roll left. The main rotor blades struck the ground and tailboom. On July 22, 1999, the engine was inspected and operated at the manufacturer's facility. No interruptions, abnormalities, or discrepancies were found. The pilot reported a total flight experience of 110.5 hours, which 98.5 hours were in the accident helicopter. He received his private pilot license on December 4, 1998.

Full narrative

On June 13, 1999, about 0930 Eastern Daylight Time, a homebuilt Rotorway Exec-90, a helicopter, N8235W, was substantially damaged while landing at a private helipad at Evington, Virginia. The certificated private pilot was not injured. Visual meteorological conditions prevailed for the local flight. No flight plan was filed for the personal flight conducted under 14 CFR Part 91.

According to his written statement, the pilot was approaching to land, traveling through transnational lift. He was applying maximum power, but did not have sufficient rotor RPM. In an attempt to increase RPM, he lowered the collective, causing the helicopter to undershoot the intended landing point. The pilot could not touchdown at this point, because the field was at a 9 to 10 degree slope angle. Additionally, he did not have enough rotor RPM to hover up-slope. He made a 180 degree turn and flew down-slope. After the turn, the forward momentum plus the 1 to 2 knot headwind slightly increased rotor RPM. However, the pilot still did not have enough power to hover. He decided to perform a slide-on landing. During the landing, the right skid struck a mound of dirt, causing the helicopter to roll left. The main rotor blades struck the ground and tailboom.

The pilot further stated that the engine may not have been developing full power. Additionally, his neighbors told him that they observed smoke emanating from the engine.

On July 22, 1999, the engine was inspected and operated at the manufacturer's facility, in the presence of a Federal Aviation Administration Inspector. No interruptions, abnormalities, or discrepancies were found.

The pilot reported a total flight experience of 110.5 hours, which 98.5 hours were in the accident helicopter. He received his private pilot license on December 4, 1998.

Probable cause

The pilot's selection of unsuitable terrain for a run on landing. A factor was the dirt bank. The National Transportation Safety Board determined the probable cause of this accident.

Circumstances

Event type
Accident
Highest injury
None
Weather conditions
Visual Meteorological Cond
Light condition
Day
Sky condition
NONE
Ceiling (ft)
0
Visibility (sm)
10
Wind direction
0
Wind speed (kt)
5
Temperature (F)
73
Distance from field
0.0

Aircraft

RegistrationMakeModelDamageFAR part
N8235W Adams ROTORWAY EXEC-90 SUBS 091

Sequence of events

#OccurrencePhase
1 320 Cruise

Findings

Finding
19200 factor
24029 cause