N9390V Mooney M20F accident

NTSB DEN99LA133 · 1999-07-31 · MONTROSE, CO

Docket — crew, injuries and powerplant

Summary

The pilot was in the process of flying his airplane (which had just undergone an annual inspection) from Evanston, Wyoming, to Durango, Colorado. While en route, an abnormally high temperature was registered on the cylinder head temperature gauge, and the engine began to run rough. The pilot made a precautionary landing on a State highway. The airplane struck several T-posts, denting the leading edge and tearing the bottom of the left wing in two places. A mechanic from a nearby airport made temporary repairs, and a ferry permit was obtained from FAA's Flight Standards District Office. Law enforcement officers would not permit the pilot to take off on the State highway, but would allow him to take off from an intersecting county road. The road was narrow, with powerlines alongside the road and crossing at irregular intervals. The pilot examined the roadway and determined he could depart safely. Traffic was halted in both directions. During the takeoff roll, the airplane's left wing struck a 4'x4' post supporting a speed limit sign.

Full narrative

On July 31, 1999, at 1102 mountain daylight time, a Mooney M20F, N9390V, registered to and operated by the pilot, was substantially damaged during takeoff near Montrose, Colorado. The private pilot, the sole occupant aboard, sustained a serious injury. Visual meteorological conditions prevailed at the time, and no flight plan had been filed for the flight being operated under Title 14 CFR Part 91. The flight was originating when the accident occurred and the intended destination was Durango, Colorado.

According to the pilot's accident report, the airplane had just received an annual inspection in Evanston, Wyoming. On July 26, he took off from Evanston to return the airplane to its home base in Durango, Colorado. While en route, an abnormally high temperature was registered on the cylinder head temperature gauge, and the engine began to run rough. The pilot made a precautionary landing on Colorado Highway 141. The airplane struck several T-posts, denting the leading edge and tearing the bottom of the left wing in two places. A mechanic from Montrose Regional Airport was summoned and temporary repairs were made. A permit obtained from FAA's Flight Standards District Office in Salt Lake City, Utah, allowed the pilot to ferry the airplane to Durango.

According to the pilot, law enforcement officers would not permit him to take off on Colorado Highway 141, but would allow the takeoff from an intersecting county road. The pilot said the road was narrow with powerlines alongside the road and crossing at irregular intervals. He examined the roadway and determined he could depart safely. Traffic was halted in both directions. During the takeoff roll, the airplane's left wing struck a 4"x4" post supporting a speed limit sign.

Probable cause

The pilot's inadequate preflight planning and preparation and his failure to maintain clearance from the signpost. A factor was the signpost. The National Transportation Safety Board determined the probable cause of this accident.

Circumstances

Event type
Accident
Highest injury
Serious
Weather conditions
Visual Meteorological Cond
Light condition
Day
Sky condition
NONE
Ceiling (ft)
0
Visibility (sm)
10
Wind direction
0
Wind speed (kt)
3
Temperature (F)
70
Distance from field
0.0

Aircraft

RegistrationMakeModelDamageFAR part
N9390V Mooney M20F SUBS 091

Sequence of events

#OccurrencePhase
1 310 Cruise

Findings

Finding
19200
20200 factor
24001 cause
24526 cause