N4859Q Cessna A188B accident

NTSB CHI00LA094 · 2000-03-21 · HAYTI, MO

Docket — crew, injuries and powerplant

Summary

The airplane had just received an annual inspection and a maintenance test flight was being performed. The pilot reported that during the flight the aileron control was ineffective. He reported that the '...right aileron appeared to be disconnected, moving up and down, [with] no response.' The pilot said that he was in a right turn and was unable to bring up the right wing. He said that he was losing altitude and decided to land the airplane on '... soft plowed ground...' The pilot said that, during the landing, the right wing struck the ground. During a postaccident examination of the aircraft, the right aileron pushrod end bearing bolt was found installed in the bellcrank, but the bolt did not pass through the rod end bearing. According to maintenance records, the aileron pushrod end bearings were replaced during the annual inspection due to excessive play. No other anomalies were found with respect to the aircraft or aircraft systems.

Full narrative

On March 21, 2000, at 1500 central standard time, a Cessna A188B, N4859Q, sustained substantial damage when it impacted the terrain during a forced landing following a loss of aileron control during flight. The 14 CFR Part 91 maintenance flight was operating in visual meteorological conditions and was not on a flight plan. The commercial rated pilot received serious injuries. The flight originated from the Mid Continent Airport, Hayti, Missouri about 1450 for a local flight.

The airplane had just received an annual inspection and a maintenance test flight was being performed. The pilot reported, in a written statement, that during the flight the aileron control was ineffective. He reported that the "...right aileron appeared to be disconnected, moving up and down, [with] no response." The pilot said that he was in a right turn and was unable to bring up the right wing. He said that he was losing altitude and decided to land the airplane on "... soft plowed ground..." The pilot said that, during the landing, the right wing struck the ground.

During a postaccident examination of the aircraft, the right aileron pushrod end bearing bolt was found installed in the bellcrank, but the bolt did not pass through the rod end bearing. According to maintenance records, the aileron pushrod end bearings were replaced during the annual inspection due to excessive play. No other anomalies were found with respect to the aircraft or aircraft systems.

Probable cause

the failure of maintenance personnel to properly install and connect the aileron control rod. Factors were the inadequate annual inspection by maintenance personnel and the aileron control not possible by the pilot. The National Transportation Safety Board determined the probable cause of this accident.

Circumstances

Event type
Accident
Highest injury
Serious
Weather conditions
Visual Meteorological Cond
Light condition
Not Reported
Sky condition
NONE
Ceiling (ft)
0
Visibility (sm)
10
Wind direction
60
Wind speed (kt)
5
Temperature (F)
57
Distance from field
0.0

Aircraft

RegistrationMakeModelDamageFAR part
N4859Q Cessna A188B SUBS 091

Sequence of events

#OccurrencePhase
1 250 Cruise
2 180 Cruise
3 230 Cruise

Findings

Finding
10729 cause
24111 cause
24104 factor
24566 factor