N3416E Cessna 172N accident

NTSB CHI00LA172 · 2000-06-26 · CANTON, MI · near 1D2

Docket — crew, injuries and powerplant

Summary

The CFI and student were practicing landings when the accident occurred. The CFI stated the student flying and the airplane began to float during the landing. The student then over corrected for the crosswind and once advised of this, the student took out some of the correction. The airplane then began to balloon so the CFI added power and the student corrected for the ballooning. The CFI stated the student then stopped correcting for the crosswind and the airplane was pushed to the left side of the runway. The CFI instructed the student to go around and the student hesitated. The CFI stated he took control of the airplane, added full power, and reduced the flap setting to 20 degrees. He stated, 'I could not get the airspeed fast enough to obtain lift and we settle[d] to the ground in the grass on the left side of the runway.' The airplane contacted soft terrain and nosed over.

Full narrative

On June 26, 2000, at 1820 eastern daylight time (edt), a Cessna 172N, N3416E, operated by a certified flight instructor (CFI) and a student pilot, nosed over during an attempted go-around at the Mettetal Airport, Canton, Michigan. The landing and go-around were being made on runway 18 (2,305 feet by x 75 feet). Neither pilot was injured. The airplane was substantially damaged. The 14 CFR Part 91 local training flight was operating in visual meteorological conditions without a flight plan. The flight originated from the Mettetal Airport at 1810 edt.

The CFI stated the purpose of the flight was to practice landings and the accident occurred on the third one which was to have been a short field landing. The CFI stated the student was making the landing and when they reached the runway, the airplane began to float. He stated the student over corrected for the crosswind and once advised of this, the student took out some of the correction. He stated the airplane then began to balloon so he (CFI) added a little power and the student corrected for the ballooning. He stated the student then stopped correcting for the crosswind and the airplane was pushed to the left side of the runway. The CFI instructed the student to go around and the student hesitated. The CFI stated he took control of the airplane, added full power, and reduced the flap setting to 20 degrees. He stated, "I could not get the airspeed fast enough to obtain lift and we settle[d] to the ground in the grass on the left side of the runway."

The CFI stated that it had been raining for the previous 4 or 5 days and the terrain was wet. He stated the nose gear sank into the soft terrain and the airplane nosed over.

The student pilot reported, "...to the best of my knowledge we attempted a go-around and the plane did not produce enough lift. Crosswinds pushed the plane off the runway slightly and after my instructor set the plane down softly the wet muddy ground caused the nosewheel to dig in and tumble."

Probable cause

the CFI delayed initiating a go-around during the landing. Factors associated with the accident were the student pilot's inadequate handling of the airplane, the crosswind condition, and the soft terrain on which the airplane touched down. The National Transportation Safety Board determined the probable cause of this accident.

Circumstances

Event type
Accident
Highest injury
None
Weather conditions
Visual Meteorological Cond
Light condition
Day
Sky condition
BKN
Ceiling (ft)
4500
Visibility (sm)
9
Wind direction
250
Wind speed (kt)
9
Temperature (F)
77
Nearest airport
METTETAL
Distance from field
0.0
Airport elevation
696

Aircraft

RegistrationMakeModelDamageFAR part
N3416E Cessna 172N SUBS 091

Sequence of events

#OccurrencePhase
1 250 Cruise
2 230 Cruise
3 300 Descent

Findings

Finding
20000 factor
24586
24500 factor
24536 cause
19200 factor