N223RS Enstrom F-28F accident

NTSB SEA01LA003 · 2000-10-10 · TWIN FALLS, ID

Docket — crew, injuries and powerplant

Summary

The pilot reported that during a maintenance test flight to check controls, collective pitch position, throttle positioning, and rpm correlation control entering an autorotation, he entered the autorotation with low rpm. When the pilot corrected with collective pitch, the correlator over responded, resulting in an rpm overspeed. The pilot closed the throttle and increased the collective, however, the rpm dropped and the pilot had to complete the autorotation to touch down on rough terrain. So as not to have any forward speed at touch down, and fearing that the helicopter might roll over, the pilot anticipated a hard flare to stop the forward speed. Just prior to touch down, the tailrotor contacted the ground, and the tailrotor gearbox separated from the tail boom. The helicopter yawed to the right about 150 degrees before the pilot was able to level the helicopter, arrest the yaw and land without further incident.

Full narrative

On October 10, 2000, about 0830 mountain daylight time, an Enstrom F-28F, N223RS, registered to and operated by Reeder & Haye Aircraft as a 14 CFR Part 91 maintenance test flight, landed hard in a field located about five miles southeast of Twin Falls, Idaho. Visual meteorological conditions prevailed at the time and no flight plan was filed for the local flight. The commercial pilot and passenger were not injured. The flight originated from Twin Falls about 30 minutes prior to the accident.

During a telephone interview and subsequent written statement, the pilot reported that this was a maintenance test flight to check controls, collective pitch position, throttle positioning, and rpm correlation control entering an autorotation. The pilot stated that during the first autorotation, the rpm was high and the correlator wanted to overspeed. During the second autorotation, the rpm was low and when the pilot corrected with collective pitch, the correlator over responded, resulting in an rpm overspeed. The pilot closed the throttle and increased the collective, however, the rpm dropped and the pilot had to complete the autorotation to touch down on rough terrain. So as not to have any forward speed at touch down, and fearing that the helicopter might roll over, the pilot anticipated a hard flare to stop the forward speed. Just prior to touch down, the tailrotor contacted the ground, and the tailrotor gearbox separated from the tail boom. The helicopter yawed to the right about 150 degrees before the pilot was able to level the helicopter, stop the yaw and land without further incident.

Probable cause

The pilot's failure to maintain adequate rotor rpm. Unsuitable terrain was selected for the maintenance test flight operation. The National Transportation Safety Board determined the probable cause of this accident.

Circumstances

Event type
Accident
Highest injury
None
Weather conditions
Visual Meteorological Cond
Light condition
Day
Sky condition
BKN
Ceiling (ft)
10000
Visibility (sm)
10
Wind direction
360
Wind speed (kt)
6
Temperature (F)
46
Distance from field
0.0

Aircraft

RegistrationMakeModelDamageFAR part
N223RS Enstrom F-28F SUBS 091

Sequence of events

#OccurrencePhase
1 230 Cruise

Findings

Finding
24558 cause
24029 factor