N31330 S.N.I.A.S SE 3130 Alouette II accident

NTSB SEA01LA043 · 2001-01-29 · Driggs, ID · near U59

Docket — crew, injuries and powerplant

Summary

The pilot reported that the flight was uneventful until the landing. When the helicopter touched down on the ramp, the cyclic control began to shake "very violently" in his hand along with the helicopter starting to move forward and aft. The pilot thought that it might be ground resonance and lifted off to a hover. The condition worsened, and the pilot increased the hover. The helicopter began to oscillate and the pilot could not stabilize the movement. The pilot then turned the helicopter to the left then back to the right to verify the location of a fuel truck. When the truck was locate, the pilot lowered the collective to land. The right rear skid contacted the surface first and the helicopter rocked forward and to the right. The helicopter rolled to the right, coming to rest on its right side. Post-accident inspection of the main rotor dampers found no mechanical failures or malfunctions.

Full narrative

On January 29, 2001, at 1630 mountain standard time, a S.N.I.A.S. SE 3130 Alouette II, N31330, registered to and operated by J.H. Jet as a 14 CFR Part 91 pleasure flight, rolled over on the ramp at Reed Memorial airport, Driggs, Idaho. Visual meteorological conditions prevailed at the time and no flight plan was filed for the local flight. The helicopter was substantially damaged and the airline transport pilot and his two passengers were not injured. The flight originated from Driggs about one hour and 30 minutes prior to the accident.

During a telephone interview and subsequent written statement, the pilot reported that the local sightseeing flight was uneventful. When they returned to the airport, the pilot entered into a hover over the departure end of runway 21 to hover taxi to the ramp. The pilot stated that the helicopter touched down on the ramp and he lowered the collective to unload the main rotor blades. At this point the cyclic control started shaking "very violently" in his hand along with the helicopter starting to move forward and aft. The pilot thought that it might be ground resonance and lifted the helicopter back off to about a three to six foot hover. The conditions worsened as the helicopter began to oscillate and could not be stabilized. The pilot raised the hover to about 10 to 12 feet, and lowered the collective thinking that it might reduce the movement. When that did not help, the pilot turned the helicopter about 90 degrees to verify the location of a fuel truck. When the truck was located, the pilot then turned the helicopter back to the right and prepared to touchdown, cautioning his passengers that the helicopter might roll after touchdown. During the landing, the right rear skid contacted the ground first and the helicopter tipped forward to the right and started to roll. The helicopter rolled over to the right and came to rest on its right side.

After the accident, the main rotor dampers were removed from the helicopter. The mechanic from Teton Aviation Center, Driggs, Idaho, performing the inspection reported that, "Functional checks of the dampers showed normal operation. Disassembled dampers and inspected, found no obvious damage or hidden damage that would cause abnormal function."

Probable cause

The pilot's failure to maintain aircraft control for undetermined reasons. The National Transportation Safety Board determined the probable cause of this accident.

Circumstances

Event type
Accident
Highest injury
None
Weather conditions
Visual Meteorological Cond
Light condition
Day
Sky condition
NONE
Ceiling (ft)
0
Visibility (sm)
10
Wind direction
210
Temperature (F)
-9
Nearest airport
Reed Memorial
Distance from field
0.0
Airport elevation
6228

Aircraft

RegistrationMakeModelDamageFAR part
N31330 S.N.I.A.S SE 3130 Alouette II SUBS 091

Sequence of events

#OccurrencePhase
1 250 Cruise
2 380 Cruise

Findings

Finding
24566 cause
25000 cause