N3143A Cessna 170B accident

NTSB ANC01LA055 · 2001-05-08 · FAIRBANKS, AK · near PAFA

Docket — crew, injuries and powerplant

Summary

The commercial certificated pilot/flight instructor was conducting a local area instructional flight with the student pilot/owner of the airplane. The flight instructor reported that he was doing wheel landings with the student to a gravel runway. During the touch down on the third or fourth landing, the tailwheel assembly suddenly broke off. An FAA airworthiness inspector examined the airplane after the accident and found a preexisting crack in the tailwheel spring assembly that was about 1/16 inch deep, and about 1/2 inch long. The spring failed at the crack. When the tail wheel departed the airplane, it struck the bottom of the rudder, and the rudder trim tab. The bottom and aft portion of the rudder assembly was torn open. The spring assembly had accrued 126 hours, and 65 hours since the last annual inspection.

Full narrative

On May 7, 2001, at 1956 Alaska daylight time, a wheel-equipped Cessna 170B airplane, N3143A, sustained substantial damage during landing at the Fairbanks International Airport, Fairbanks, Alaska. The airplane was being operated as a visual flight rules (VFR) local area instructional flight when the accident occurred. The airplane was operated by the student pilot/owner. The commercial certificated pilot/flight instructor, and the student pilot, were not injured. Visual meteorological conditions prevailed. The flight originated at the Fairbanks International Airport at 1917.

During a telephone conversation with the National Transportation Safety Board (NTSB) investigator-in-charge (IIC), on May 9, 2001, the flight instructor reported that he was seated in the right seat, and was conducting wheel landings with the student on the ski strip, runway 19, at Fairbanks. During the touchdown on the third or fourth landing, the tailwheel assembly suddenly broke off.

A Federal Aviation Administration (FAA) airworthiness inspector, Fairbanks Flight Standards District Office (FSDO), examined the airplane after the accident. He reported he found a preexisting crack in the tailwheel spring assembly that was about 1/16 inch deep, and about 1/2 inch long. He said the spring failed at the crack, and when the tailwheel departed the airplane, it struck the bottom of the rudder, and the rudder trim tab. The bottom and aft portion of the rudder assembly was torn open.

In the Pilot/Operator Report (NTSB form 6120.1/2) submitted by the student pilot/owner, the owner indicated the tailwheel spring had a total time of 162 hours. The 6120.1/2 report noted an annual inspection was conducted on November 6, 2000, 65 hours before the accident.

Probable cause

A failure of the tailwheel spring assembly due to fatigue during touch and go landings. A factor in the accident was an inadequate annual inspection by maintenance personnel. The National Transportation Safety Board determined the probable cause of this accident.

Circumstances

Event type
Accident
Highest injury
None
Weather conditions
Visual Meteorological Cond
Light condition
Day
Sky condition
BKN
Ceiling (ft)
5500
Visibility (sm)
10
Wind direction
184
Wind speed (kt)
3
Temperature (F)
45
Nearest airport
FAIRBANKS INTERNATIONAL
Distance from field
0.0
Airport elevation
434

Aircraft

RegistrationMakeModelDamageFAR part
N3143A Cessna 170B SUBS 091

Sequence of events

#OccurrencePhase
1 130 Cruise

Findings

Finding
10409 cause
24104 factor