N4598 Grumman-Schweizer G-164A accident

NTSB CHI01LA286 · 2001-08-16 · Petersburg, NE

Docket — crew, injuries and powerplant

Summary

The airplane was damaged during a forced landing following a loss of engine power during an aerial-application flight. The pilot reported, "While spraying at 6 [feet] AGL the engine began running rough and quit. I made an emergency landing in a muddy soybean field, sliding to a stop damaging the right lower wing and right landing gear." A postaccident examination of the airplane revealed that the number 8 cylinder head had separated from the cylinder barrel between the second and third cooling fins. This condition is identified in Pratt and Whitney Airworthiness Directive (AD) 78-08-07. The AD requires a recurring visual inspection of the cylinder at 150 hour or 100 hour intervals. Cylinders that had been ultrasonically tested prior to installation on the engine were to be inspected at 150 hour intervals. Cylinders that had not been ultrasonically tested prior to installation on the engine were to be inspected at 100 hour intervals . According to the aircraft maintenance records, the airplane had accumulated 99.8 hours time in service since the inspection was last performed. It is not known if the failed cylinder had been ultrasonically inspected.

Full narrative

On August 16, 2001, about 1615 central daylight time, a Grumman-Schweizer G-164A, piloted by a commercial pilot, sustained substantial damage during a forced landing following a loss of engine power during an aerial-application flight near Petersburg, Nebraska. The 14 CFR Part 137 flight was operating in visual meteorological conditions and was not on a flight plan. The pilot, who was the sole occupant, was not injured. The local flight originated from the Antelope County Airport, Neligh, Nebraska, about 1515.

The pilot reported, "While spraying at 6 [feet] AGL the engine began running rough and quit. I made an emergency landing in a muddy soybean field, sliding to a stop damaging the right lower wing and right landing gear."

A postaccident examination of the airplane revealed that the number 8 cylinder head had separated from the cylinder barrel between the second and third cooling fins. This condition is identified in Pratt and Whitney Airworthiness Directive (AD) 78-08-07. The AD requires a recurring visual inspection of the cylinder at 150 hour or 100 hour intervals. Cylinders that had been ultrasonically tested prior to installation on the engine were to be inspected at 150 hour intervals. Cylinders that had not been ultrasonically tested prior to installation on the engine were to be inspected at 100 hour intervals . According to the aircraft maintenance records, the airplane had accumulated 99.8 hours time in service since the inspection was last performed. It is not known if the failed cylinder had been ultrasonically inspected.

Probable cause

The failure of the engine cylinder, and the unsuitable terrain for landing encountered by the pilot. Factors were the low altitude and the muddy field. The National Transportation Safety Board determined the probable cause of this accident.

Circumstances

Event type
Accident
Highest injury
None
Weather conditions
Visual Meteorological Cond
Light condition
Day
Sky condition
NONE
Ceiling (ft)
0
Visibility (sm)
10
Wind direction
320
Wind speed (kt)
10
Temperature (F)
75
Distance from field
0.0

Aircraft

RegistrationMakeModelDamageFAR part
N4598 Grumman-Schweizer G-164A SUBS 137

Sequence of events

#OccurrencePhase
1 351 Cruise
2 180 Cruise
3 230 Cruise

Findings

Finding
14007 cause
24518 factor
19200 factor
24029 cause