N923MC Bell OH-58A accident

NTSB MIA01LA231 · 2001-09-27 · Sevierville, TN

Docket — crew, injuries and powerplant

Summary

The pilot stated that as he approached his landing zone, while about 3 feet agl, the helicopter veered to the left. He corrected using right cyclic and by lowering the collective. The helicopter touched down hard causing a tailrotor strike and the main rotor to strike the tail boom. Postcrash examination of the helicopter at the crash site by an FAA Inspector, and after recovery from the crash site by an FAA Inspector and a representative of Bell Helicopter confirmed that continuity of flight control components existed at the time of impact, and that there was freedom of movement throughout the flight control systems after recovery. The examination confirmed that there was a high rate of rotation of the drive train components at the time of impact. There were no preimpact airframe anomalies identified.

Full narrative

On September 27, 2001, about 1720 eastern daylight time, a Bell OH-58A, N923MC, registered to Vista-Dome Simulation Corporation, crashed during landing near Sevierville, Tennessee, while on a 14 CFR 91 aerial filming flight. Visual meteorological conditions prevailed at the time and no flight plan was filed. The helicopter received substantial damage and the commercial-rated pilot and one passenger were not injured. The flight originated from Sevierville, Tennessee, the same day, about 1645.

The pilot stated that he was flying the helicopter from the right front seat and his passenger was in the left front seat. As he approached his landing zone, while about 3 feet agl, the helicopter veered to the left. He corrected using right cyclic and by lowering the collective. The helicopter touched down hard causing a tailrotor strike and the main rotor to strike the tail boom.

Postcrash examination of the helicopter at the crash site by an FAA Inspector, and after recovery from the crash site by an FAA Inspector and a representative of Bell Helicopter confirmed that continuity of flight control components existed at the time of impact, and that there was freedom of movement throughout the flight control systems after recovery. The examination confirmed that there was a high rate of rotation of the drive train components at the time of impact. There were no preimpact airframe anomalies identified. Cyclic controls were installed in both the left and right front seat positions. (See Bell Helicopter report, an attachment to this report)

Probable cause

The failure of the pilot to maintain control of the helicopter while approach to land resulting in a hard landing, a tail rotor ground strike, and the main rotor striking the tail boom. The National Transportation Safety Board determined the probable cause of this accident.

Circumstances

Event type
Accident
Highest injury
None
Weather conditions
Visual Meteorological Cond
Light condition
Day
Sky condition
NONE
Ceiling (ft)
0
Visibility (sm)
10
Wind direction
280
Wind speed (kt)
6
Temperature (F)
72
Distance from field
0.0

Aircraft

RegistrationMakeModelDamageFAR part
N923MC Bell OH-58A SUBS 091

Sequence of events

#OccurrencePhase
1 250 Cruise
2 200 Cruise

Findings

Finding
24566 cause