N112JF D'Apuzzo D-260 accident

NTSB NYC02LA093 · 2002-05-05 · Andover, NJ · near 12N

Docket — crew, injuries and powerplant

Summary

The pilot stated that as the airplane touched down on the runway, he heard a "pop," and the left main gear collapsed. Two witnesses reported that the airplane touched down hard, and with a side load on the landing gear. Examination of the left main landing gear revealed that two 5/16-inch bolts secured the spring gear to the airframe. One of the two bolts had sheared, and the other was bent. According to a Safety Board Metallurgist, the bolt failure was consistent with a direct shear ductile overstress separation.

Full narrative

On May 5, 2002, about 1000 eastern daylight time, a D'Apuzzo D-260 homebuilt airplane, N112JF, was substantially damaged while landing at Aeroflex-Andover Airport (12N), Andover, New Jersey. The certificated private pilot was not injured. Visual meteorological conditions prevailed and no flight plan was filed for the personal flight conducted under 14 CFR Part 91.

The pilot stated that about 0930, he departed a private airstrip in Nazareth, Pennsylvania, and flew to 12N. As the airplane touched down on runway 21, the pilot heard a "pop". The left main gear collapsed, and the airplane traveled off the left side of the runway. It came to rest in the grass, and the lower left wing spar sustained damage. The pilot added that he did not land hard.

A witness stated that the airplane touched down hard and the landing gear sustained a side load. The witness then heard a "pop," and the airplane veered left.

Another witness reported: "...the plane approach at a severe sideway angle. The plane attempted to straighten out but was unable to do so. As the plane touched down it bounced hard."

Examination of the left main landing gear by a Federal Aviation Administration inspector revealed that two 5/16-inch bolts secured the spring gear to the airframe. One of the two bolts had sheared, and the other was bent. The sheared bolt was forwarded to the Safety Board's Material Laboratory for further examination. According to a Safety Board Metallurgist, the failure was consistent with a direct shear ductile overstress separation.

The reported wind at an airport approximately 10 miles northeast of the accident site, at 0953, was variable at 3 knots.

Probable cause

The pilot's failure to obtain proper runway alignment while landing, which resulted in a gear collapse. The National Transportation Safety Board determined the probable cause of this accident.

Circumstances

Event type
Accident
Highest injury
None
Weather conditions
Visual Meteorological Cond
Light condition
Day
Sky condition
NONE
Ceiling (ft)
0
Visibility (sm)
10
Wind direction
0
Wind speed (kt)
3
Temperature (F)
59
Nearest airport
Aeroflex-Andover Airport
Distance from field
0.0
Airport elevation
583

Aircraft

RegistrationMakeModelDamageFAR part
N112JF D'Apuzzo D-260 SUBS 091

Sequence of events

#OccurrencePhase
1 190 Cruise
2 260 Cruise
3 320 Cruise

Findings

Finding
24530 cause
19200