N61439 Schweizer 269C-1 accident

NTSB FTW02LA201 · 2002-07-07 · Waco, TX

Docket — crew, injuries and powerplant

Summary

During initial climb, while climbing through an estimated altitude of approximately 200 feet above the ground, the engine "sputtered" a few times, and then cleared itself. After the engine "sputtered" a second time, the pilot initiated an autorotation with a 180-degree turn. The pilot added that during the turn, the airspeed decreased and he lowered the nose of the helicopter to attempt to regain the airspeed. The helicopter landed hard in a slight nose low attitude and slid for about 50 feet. The toes of the landing gear skids dug into the soft ground and the helicopter nosed over, coming to rest on its right side. No anomalies were found with the engine that could have prevented normal operation.

Full narrative

On July 7, 2002, at 1830 central daylight time, a Schweizer 269C-1 helicopter, N61439, was substantially damaged during a hard landing following a partial loss of engine power during initial climb from a private airstrip near Waco, Texas. The commercial pilot and his passenger were not injured. The helicopter was owned by the Schweizer Aircraft Corporation of Big Flats, New York, and was being operated by Heart of Texas Helicopters of Waco, Texas. Visual meteorological conditions prevailed for the 14 Code of Federal Regulations Part 91 personal flight for which no flight plan was filed. The local flight originated from a grass airstrip operated by Heart of Texas Helicopters, at 1820.

In a telephone interview with the NTSB investigator-in-charge, the pilot reported that the purpose of the flight was to conduct a local orientation flight, which included demonstrating a quick-stop maneuver, a standard straight-in autorotation, and an autorotation with a 180-degree turn.

The pilot reported that after taking off to the south, during the initial climb, while climbing through an estimated altitude of approximately 200 feet above the ground, the engine "sputtered" a few times, and then cleared itself. After the engine "sputtered" a second time, the pilot initiated an autorotation with a 180-degree turn in an attempt to return to the runway.

The pilot added that during the turn, the airspeed decreased, and he lowered the nose of the helicopter in an attempt to regain the airspeed. The helicopter landed hard in a slight nose low attitude and slid for about 50 feet. The toes of the landing gear skids dug into the soft ground and the helicopter nosed over coming to rest on its right side. The pilot reported that he had accumulated over 1,500 hours, with approximately 600 hours in the same make and model helicopter.

An examination of the helicopter, by the operator and a representative of the airframe manufacturer, revealed two of the main rotor blades were separated from the head outboard of the root doublers. The other blade remained attached; however, it was severely bent down. All three main rotor blades showed evidence of ground contact. Flight control continuity was established to the rotor head and the tail rotor. The tailboom was separated from the airframe, with indications of blade strikes. The left landing gear was intact and remained attached. The right landing gear was fractured.

The fuel tank contained an undetermined amount of fuel. No discrepancies were found with the engine that would have prevented normal operations. .

Probable cause

The partial loss of engine power due to undetermined reasons. A contributing factor was the pilot's inadequate landing flare which resulted in a hard landing. The National Transportation Safety Board determined the probable cause of this accident.

Circumstances

Event type
Accident
Highest injury
None
Weather conditions
Visual Meteorological Cond
Light condition
Day
Sky condition
NONE
Ceiling (ft)
0
Visibility (sm)
10
Wind direction
90
Wind speed (kt)
6
Temperature (F)
93
Distance from field
0.0

Aircraft

RegistrationMakeModelDamageFAR part
N61439 Schweizer 269C-1 SUBS 091

Sequence of events

#OccurrencePhase
1 350 Cruise
2 180 Cruise
3 200 Cruise

Findings

Finding
25000 cause
24520
24518
24535 factor