N4949 Curtiss-Wright Travel Air 4000 accident

NTSB SEA03LA001 · 2002-10-05 · Tillamook, OR · near S47

Docket — crew, injuries and powerplant

Summary

The pilot preflighted the 1928 Curtiss Wright Travel Air 4000 and departed with two passengers on a short, local sightseeing flight. Upon landing the aircraft veered left off the runway nosing over and coming to rest inverted in the grass. Post crash examination revealed that the original weld between the left-right main wheel axle and the left wheel "V" strut had fractured allowing the left strut and wheel axel to separate and the left wheel to subsequently collapse/shift during the landing roll. Although company personnel on the ground observed the aircraft prior to landing and noted the left main gear "hanging down" they were unable to contact the pilot by radio and the pilot's view of the main wheels was obstructed in flight.

Full narrative

On October 5, 2002, approximately 1345 Pacific daylight time, a Curtiss Wright Travel Air 4000, N4949, registered to and being flown by a commercial pilot, and operated by Tillamook Air Tours, sustained substantial damage during the landing roll when the aircraft's left main gear collapsed and the aircraft nosed over at the Tillamook airport, Tillamook, Oregon. The pilot and two passengers were uninjured. The pilot reported the weather conditions as "calm and cool" and no flight plan had been filed. The 14 CFR 91 sightseeing flight originated from the Tillamook airport approximately 1300.

The pilot reported that he preflighted the aircraft and then departed Tillamook airport on a 45-minute local sightseeing flight with two passengers. Upon landing on runway 31 the pilot noted the aircraft began pulling left and he heard a "thumping" sound. The aircraft departed the west side of the runway rolling into a grassy area and then nosed over (refer to photograph 1). The pilot also reported that company personnel on the ground at Tillamook airport observed the aircraft prior to landing and noted the left main gear "hanging down" but were unable to contact the pilot by radio. The pilot reported that the wheels are not visible from the rear cockpit in flight.

Two inspectors assigned to the Federal Aviation Administration's (FAA) Hillsboro, Oregon, Flight Standards District Office conducted post-accident inspection of the aircraft. The examination revealed that the weld between the left-right main wheel axle and the left wheel "V" strut had fractured (refer to photograph 2). The FAA inspectors interviewed the individual who restored the 1928 vintage aircraft and determined that the wheel axle to gear strut welds (left and right) were original welds and had not been replaced or altered during the restoration process.

Probable cause

The fracture of the weld joining the left main wheel strut to the left/right main wheel axel resulting in separation of the strut from the axle during an unknown phase of operation which ultimately lead to the left gear collapse and subsequent nose-over on landing roll. The National Transportation Safety Board determined the probable cause of this accident.

Circumstances

Event type
Accident
Highest injury
None
Weather conditions
Visual Meteorological Cond
Light condition
Day
Sky condition
OVC
Ceiling (ft)
3100
Visibility (sm)
10
Wind direction
30
Temperature (F)
61
Nearest airport
Tillamook
Distance from field
0.0
Airport elevation
35

Aircraft

RegistrationMakeModelDamageFAR part
N4949 Curtiss-Wright Travel Air 4000 SUBS 091

Sequence of events

#OccurrencePhase
1 191 Cruise
2 300 Cruise

Findings

Finding
11303 cause
10412
10403