N2443R Cessna 182G accident

NTSB LAX02LA301 · 2002-09-28 · PARADISE, CA · near Q88

Docket — crew, injuries and powerplant

Summary

The pilot made a hard landing collapsing the nose gear and damaging the firewall. The pilot took off and turned to downwind for landing. He reported that he flew an uneventful and normal approach. He said that he touched down on the main landing gear, but the nose gear folded under the airplane as it touched down. An examination of the runway by the Federal Aviation Administration accident coordinator revealed a skid mark on the runway at the touchdown point. He also observed gouges on the runway surface and chunks of displaced runway material. The nose wheel deformed and buckled inboard along one quadrant. The nose gear fork fractured in several places; these fracture surfaces were irregular and rough in appearance. The fork split along its lateral axis, and the aft half of the fork also split parallel to the longitudinal axis. The aft half of the nose gear collar and a section of the aft fork fractured and separated. The fork fracture surface angled about 45 degrees to the surface, and had an uneven and grainy surface. The firewall sustained upward crush damage, and was buckled. The bottom and sides of the fuselage were buckled aft of the main landing gear.

Full narrative

On September 28, 2002, at 0915 Pacific daylight time, a Cessna 182, N2443R, made a hard landing at Paradise (Q88), California. Skydive at Paradise was operating the airplane under the provisions of 14 CFR Part 91. The commercial pilot, the sole occupant, was not injured; the airplane sustained substantial damage. The personal local flight departed Paradise about 15 minutes prior to the accident. Visual meteorological conditions prevailed, and no flight plan had been filed. This accident was initially recorded as an incident, but a Federal Aviation Administration (FAA) inspector upgraded it to an accident after examination of the airplane on October 8, 2002.

The pilot stated that company policy required a test flight prior to the first jump load. The pilot took off and turned to downwind for landing. He reported that he flew an uneventful and normal approach. He touched down on the main landing gear, but the nose gear folded under the airplane as it touched down.

The FAA accident coordinator examined the airplane and runway. He noted a skid mark on the runway at the touchdown point. He also observed gouges on the runway surface and chunks of displaced runway material.

The nose wheel deformed and buckled inboard along one quadrant. The nose gear fork fractured in several places; these fracture surfaces were irregular and rough in appearance. The fork split along its lateral axis, and the aft half of the fork also split parallel to the longitudinal axis. The aft half of the nose gear collar and a section of the aft fork fractured and separated. The fork fracture surface angled about 45 degrees to the surface, and had an uneven and grainy surface.

The nose strut displaced aft, and pushed up into the firewall and belly of the fuselage. The firewall exhibited upward crush damage, and it buckled.

The bottom and sides of the fuselage buckled aft of the main landing gear.

Probable cause

the pilot's improper flare resulting in a hard landing. The National Transportation Safety Board determined the probable cause of this accident.

Circumstances

Event type
Accident
Highest injury
None
Weather conditions
Visual Meteorological Cond
Light condition
Day
Sky condition
NONE
Ceiling (ft)
0
Visibility (sm)
10
Wind direction
170
Wind speed (kt)
6
Temperature (F)
63
Nearest airport
Paradise Skypark
Distance from field
0.0
Airport elevation
1300

Aircraft

RegistrationMakeModelDamageFAR part
N2443R Cessna 182G SUBS 091

Sequence of events

#OccurrencePhase
1 200 Cruise
2 192 Cruise

Findings

Finding
24535 cause