N162AZ Rotorway 162F accident

NTSB LAX03LA011 · 2002-10-19 · Tucson, AZ · near RYN

Docket — crew, injuries and powerplant

Summary

Following a drive shaft failure, the helicopter collided with high vegetation and rolled over during an autorotation. In a statement to a Federal Aviation Administration (FAA) inspector, the pilot reported that while performing pattern and ground reference maneuvers, the helicopter experienced a mechanical malfunction. The pilot executed an autorotation and contacted high vegetation with the helicopter's right skid, resulting in the helicopter rolling to the left and impacting terrain. The pilot disposed of the helicopter in a waste dump prior to examination by FAA inspectors and the nature of the mechanical malfunction could not be determined. In a telephone interview with a Safety Board investigator, the pilot reported that the secondary shaft broke in half, resulting in a loss of drive power to the helicopter's main rotor. The pilot was aware of the advisory service bulletin issued by the kit manufacturer suggesting replacement of the secondary shaft assembly, but had not complied. Beginning in May 1995, the kit manufacturer released four separate Advisory Bulletins (A-23, A-26, A-32 and A-34) addressing installation, inspection, and shaft design change issues. Citing a history of secondary shaft failures, the most recent advisory bulletin at the time of the accident, issued May 2002, recommended replacement of the standard 30 mm secondary shaft with an upgraded 35 mm shaft.

Full narrative

On October 19, 2002, about 1150 mountain standard time, a homebuilt Rotorway 162F, N162AZ, collided with terrain during a forced landing about 5 miles south of Ryan Field Airport, Tucson, Arizona. The pilot/owner was operating the helicopter under the provisions of 14 CFR Part 91. The private pilot, the sole occupant, was not injured; the helicopter was destroyed. Visual meteorological conditions prevailed and a flight plan had not been filed. The personal local flight originated about 1140 from Ryan Field.

In a statement collected by a Federal Aviation Administration (FAA) inspector, the pilot reported that while performing pattern and ground reference maneuvers, the helicopter experienced a mechanical malfunction. The pilot executed an autorotation and contacted high vegetation with the helicopter's right skid, resulting in the helicopter rolling to the left and impacting terrain. The pilot's disposal of the helicopter in a waste dump prior to examination prevented the FAA from performing an inspection to determine the nature of the mechanical malfunction.

In a telephone interview with a National Transportation Safety Board investigator, the pilot reported that the secondary shaft broke in half, resulting in a loss of power to the helicopter's main rotor. The pilot was aware of the advisory service bulletin issued by the manufacturer suggesting replacement of the secondary shaft assembly, but had not complied.

Beginning in May 1995, the kit manufacturer released four separate Advisory Bulletins (A-23, A-26, A-32 and A-34) addressing installation, inspection, and shaft design change issues. Concerned about shaft failures, the most recent advisory bulletin at the time of the accident, issued May 2002, recommended replacement of the standard 30 mm secondary shaft with an upgraded 35 mm shaft.

After the accident, and following a secondary shaft failure accident in a Rotorway Exec 90 on February 4, 2003, the manufacturer issued a Mandatory Compliance Bulletin (M-21). The bulletin required owners of all Exec 90 and Exec 162F helicopters to comply with a periodic inspection of the secondary drive assembly at 100-hour intervals. The bulletin further mandated immediate inspection of the secondary shaft if the helicopter had previously sustained a tail rotor strike.

Despite repeated attempts, the Safety Board was unable to follow-up with the pilot/owner concerning the maintenance history of the helicopter or obtain a completed NTSB 6120.1/2 form.

Probable cause

the failure of the secondary drive shaft. The National Transportation Safety Board determined the probable cause of this accident.

Circumstances

Event type
Accident
Highest injury
None
Weather conditions
Visual Meteorological Cond
Light condition
Day
Sky condition
NONE
Ceiling (ft)
0
Visibility (sm)
10
Wind direction
0
Temperature (F)
72
Nearest airport
Ryan Field Airport
Distance from field
5.0
Airport elevation
2417

Aircraft

RegistrationMakeModelDamageFAR part
N162AZ Rotorway 162F DEST 091

Sequence of events

#OccurrencePhase
1 130 Cruise
2 180 Cruise
3 320 Cruise
4 380 Cruise

Findings

Finding
11001 cause
24520
19200