N70TV Bell 206-L4 accident

NTSB DEN03LA078 · 2003-05-08 · Aurora, CO

Docket — crew, injuries and powerplant

Summary

According to the pilot-in-command (PIC), the helicopter was returning to Centennial Airport, Englewood, after the crew had filmed a news story. He was allowing the check pilot (CP) to fly the helicopter. The PIC "bumped the throttle" to simulate a power loss. The CP turned into the wind and slowed to 60 knots. The PIC consulted the CP and confirmed the landing location and recovery procedures (i.e., rotor rpm in the green arc, full throttle at 200 feet agl). The CP flared the helicopter 75 feet above the ground but didn't apply power until they were 20 feet above the ground. Rotor speed decayed, and the helicopter struck the ground, bounced, spun 180 degrees, and rolled over on its left side. According to the CP, the PIC initiated a forced landing. He wrote, "I entered the [autorotation] and turned into the wind. During the power recovery, the engine did not respond in a timely manner and ground contact was the result." According to the FAA inspector who interviewed the crew, the CP did not have recent helicopter experience involving operations above 5,000 feet. Due to a lack of prior planning between the two pilots, "the [CP] assumed that the PIC was going to reapply the throttle for a power recovery. At the same time, the [PIC] assumed that the [CP] was going to apply power [to recover]. The result of this lack of CRM (cockpit resource management) was that the power was applied at a point where the descent rate could not be arrested..." At the time of the accident, the helicopter was carrying 400 pounds of fuel, television cameras and other equipment, and a cameraman. The density altitude was computed to be 7,143 feet msl.

Full narrative

On May 8, 2003, approximately 1715 mountain daylight time, a Bell 206-L4, N70TV, registered to and operated by Helicopters, Inc., of Cahokia, Illinois, and doing business as KMGH-TV, Denver Colorado, was substantially damaged when it collided with terrain during a simulated engine failure in Aurora, Colorado. The airline transport pilot certificated check airman received minor injuries, and the commercial certificated pilot-in-command and a mechanic-passenger were not injured. Visual meteorological conditions prevailed, and no flight plan had been filed for the business flight being conducted under Title 14 CFR Part 91. The flight originated at Englewood, Colorado, approximately 1645.

According to the accident report submitted by the pilot-in-command (PIC), the helicopter was returning to Centennial Airport, Englewood, after the crew had filmed a news story. The PIC was allowing the check pilot (CP) to fly the helicopter. The PIC said he "bumped the throttle" to simulate a power loss. The CP turned into the wind and slowed to 60 knots. The PIC consulted the CP and confirmed the landing location and recovery procedures (i.e., rotor rpm in the green arc, full throttle at 200 feet agl). The CP flared the helicopter 75 feet above the ground but didn't apply power until they were 20 feet above the ground. Rotor speed decayed, and the helicopter struck the ground, bounced, spun 180 degrees, and rolled over on its left side. The main rotor blades severed the tail boom.

According to the accident report submitted by the CP, the PIC initiated a forced landing. He wrote, "I entered the [autorotation] and turned into the wind. During the power recovery, the engine did not respond in a timely manner and ground contact was the result."

An FAA inspector went to the scene and interviewed the crew. According to the inspector's report, the CP did not have recent helicopter experience involving operations above 5,000 feet. Due to a lack of prior planning between the two pilots, "the [CP] assumed that the PIC was going to reapply the throttle for a power recovery. At the same time, the [PIC] assumed that the [CP] was going to apply power [to recover]. The result of this lack of CRM (cockpit resource management) was that the power was applied at a point where the descent rate could not be arrested..."

At the time of the accident, the helicopter was carrying 400 pounds of fuel, television cameras and other equipment, and a cameraman. The density altitude was computed to be 7,202 feet msl.

Probable cause

inadequate infligt planning/decision by the flight crew and the check pilot's failure to initiate remedial action in a timely manner. Contributing factors were the pilot-in-command's inadequate supervision of the check pilot, the check pilot's lack of recency of high altitude experience, and the high density altitude. The National Transportation Safety Board determined the probable cause of this accident.

Circumstances

Event type
Accident
Highest injury
Minor
Weather conditions
Visual Meteorological Cond
Light condition
Day
Sky condition
BKN
Ceiling (ft)
10000
Visibility (sm)
15
Wind direction
100
Wind speed (kt)
9
Temperature (F)
57
Distance from field
0.0

Aircraft

RegistrationMakeModelDamageFAR part
N70TV Bell 206-L4 SUBS 091

Sequence of events

#OccurrencePhase
1 230 Cruise

Findings

Finding
20000 factor
24010 cause
24545
24520
24542 cause
24627 factor
34345 factor