N87198 Engineering & Research 415-C accident

NTSB CHI03LA165 · 2003-06-14 · Independence, KS · near IDP

Docket — crew, injuries and powerplant

Summary

The airplane sustained substantial damage during a forced landing in a farm field following a total loss of engine power six miles from the destination airport. Inspection of the airplane revealed that at least one fuel cap was placed on backwards. No other anomalies to fuel system were noted. According to the pilot's operating handbook, if the fuel caps are placed on the airplane backwards, the fuel system may malfunction because the fuel system will be unable to vent and provide equal fuel flow to the tanks. Unequal flow may result in the fuel pump being unable to pump fuel to the fuselage tank.

Full narrative

On June 14, 2003, at 1127 central daylight time, an Engineering & Research Corporation 415-C (Ercoupe), N87198, owned and piloted by a private pilot, sustained substantial damage during a forced landing following a total loss of engine power near Independence, Kansas. Visual meteorological conditions prevailed at the time of the accident. The 14 CFR Part 91 personal flight was not operating on a flight plan. The pilot and the passenger were uninjured. The flight originated from Colonel James Jabara Airport (AAO), Wichita, Kansas, at 1030, and was en route to Independence Municipal Airport (IDP), Independence, Kansas.

The airplane was about six nautical miles northwest from (IDP) when it experienced a total loss of engine power. The pilot stated he made a forced landing on a farm field.

A post accident investigation by a Federal Aviation Administration (FAA) inspector revealed the following: No obstructions were found in the main gascolator, fuel pump, and carburetor fuel screens. The carburetor, fuel pump, and return lines from the fire wall did not contain obstructions. The fuselage gravity feed fuel tank was empty, while the remaining fuel in the wing tanks measured to be five gallons. The engine driven pump was primed by hand and pumped fuel.

A certified mechanic reported that at least one of the fuel caps on the wing tanks was found to be on backwards. According to the Ercoupe operating manual, "It has been the experience of some Ercoupe owners and operators that line mechanics put the wing tank caps on backwards. To prevent malfunctioning of the fuel system, it is imperative that the caps be put on the tanks with the vent hole to the front. This provides venting of each wing tank and will prevent syphoning or unequal flow of the fuel. Unequal flow may result in the fuel pump being unable to transfer all of the fuel from the wing tanks to the fuselage tank."

The manual further states, "The sealing of the cap gasket also effects proper venting. If difficulty is experienced in attaining a good seal of the gas cap, which is an un-machined casting, the sealing surface may be filed smooth and the gasket cemented to this surface. Should there be an excessive amount of solder on the filler neck sealing surface, it may also be removed by filing."

Probable cause

A loss of engine power due to fuel starvation. A factor to the accident was the pilot's improper installation of the fuel cap. The National Transportation Safety Board determined the probable cause of this accident.

Circumstances

Event type
Accident
Highest injury
None
Weather conditions
Visual Meteorological Cond
Light condition
Day
Sky condition
NONE
Ceiling (ft)
0
Visibility (sm)
10
Wind direction
120
Wind speed (kt)
7
Temperature (F)
82
Nearest airport
Independence Municipal Airport
Distance from field
6.0
Airport elevation
825

Aircraft

RegistrationMakeModelDamageFAR part
N87198 Engineering & Research 415-C SUBS 091

Sequence of events

#OccurrencePhase
1 353 Cruise
2 180 Cruise
3 320 Cruise

Findings

Finding
15114 factor
15100 cause
24704 factor
19200