N9067A Cessna 170A accident

NTSB NYC03LA144 · 2003-06-27 · Newcomerstown, OH

Docket — crew, injuries and powerplant

Summary

The pilot was landing to the north on a 1,200-foot-long, 30-foot-wide, turf runway. The runway contained a 300-foot-long flat touchdown area, followed by an incline of about 30-percent. The airplane touched down halfway down the runway and bounced. The pilot initiated a go-around; however, as the airplane climbed, the pilot observed two hay bales located about 30 feet beyond the end of the runway. He tried to avoid the hay bales by making a quick right turn, but the left side of the horizontal stabilizer hit the top of one of the bales. The airplane then pitched down and struck the ground nose first. The pilot did not over fly the field prior to the landing attempt, and was not aware of the hay bales until the airplane reached the crest of the runway.

Full narrative

On June 27, 2003, about 1650 eastern daylight time, a Cessna 170A, N9067A, was substantially damaged during an aborted landing at a private airstrip in Newcomerstown, Ohio. The certificated commercial pilot and a passenger sustained minor injuries. Visual meteorological conditions prevailed, and no flight plan was filed for the flight that departed the Richard Downing Airport (I40), Coshocton, Ohio. The personal flight was conducted under 14 CFR Part 91.

The pilot stated that the purpose of the flight was to familiarize the passenger with the location of several local private grass strips.

The airplane was landing to the north on a 1,200-foot-long, 30-foot-wide, turf runway. The pilot reported that the runway contained a 300-foot-long flat touchdown area, followed by an incline of about 30-percent. In addition, two 40-foot tall trees were located about 100 feet before the threshold.

The pilot described the approach as normal. He further stated that the airplane was about 5 knots fast and a little high, because his attention was divided between flying the approach, and pointing out several features of the strip to the passenger. The airplane touched down halfway down the runway and bounced. The pilot initiated a go-around; however, as the airplane climbed, the pilot observed two hay bales at the end of the runway. He tried to avoid the hay bales by making quick right turn, but the left side of the horizontal stabilizer hit the top of one of the bales. The airplane then pitched down and struck the ground nose first.

The hay bales were located about 30 feet beyond the end of the runway. The pilot stated he did not observe the hale bales until the airplane reached the crest of the runway, and he should have over flown the field to determine if any changes had occurred since his last landing attempt at the strip.

The pilot reported 626 hours of total flight experience, which included 115 hours in the make and model of the accident airplane.

The reported winds at an airport about 22 miles northeast of the accident site, at 1653, were variable at 6 knots.

Probable cause

The pilot's failure to obtain the proper touchdown point and delayed go-around. Factors in this accident were the up sloping runway. The National Transportation Safety Board determined the probable cause of this accident.

Circumstances

Event type
Accident
Highest injury
Minor
Weather conditions
Visual Meteorological Cond
Light condition
Day
Sky condition
NONE
Ceiling (ft)
0
Visibility (sm)
10
Wind direction
0
Wind speed (kt)
6
Temperature (F)
75
Nearest airport
ARTH (Private)
Distance from field
0.0
Airport elevation
1100

Aircraft

RegistrationMakeModelDamageFAR part
N9067A Cessna 170A SUBS 091

Sequence of events

#OccurrencePhase
1 220 Cruise

Findings

Finding
19200 factor
20200
24531 cause
24536 cause