N299UX Embraer EMB-120ER accident

NTSB DEN03LA096 · 2003-06-02 · Denver, CO · near DEN

Docket — crew, injuries and powerplant

Summary

According to the pilot, he was "following the ramp agent's marshalling signals" while parking the airplane. He initiated a right turn as signaled and stopped when he lost sight of the ramp agent. The ramp agent had bent down to move a set of wheel chocks. The ramp agent "came back into [the pilot's] view after a few seconds and gave [him] the command to continue [his] right turn." Once the turn was initiated, it "became difficult to move [the airplane] without having to use more power than should be required." The pilot stopped the airplane and upon exiting, discovered that the airplane had come in contact with one of the ramp vehicles." The airplane's right aft fuselage was crushed inward puncturing the aft cabin pressure bulkhead. The tug operator stated he had observed the airplane stop and thought it was finished parking and ready for service. He positioned the tug and baggage cart behind the airplane to unload baggage. The airplane began to move again and he was unable to move the tug before the collision occurred. The ramp agent did not see the tug move in behind the airplane prior to re-initiating the airplane turn.

Full narrative

On June 2, 2003, approximately 1740 mountain daylight time, an Embraer, EMB-120ER, N299UX, operated by Great Lakes Aviation as flight 5120, was substantially damaged when it struck a ramp vehicle while taxiing to its gate at Denver International Airport (DEN), Denver, Colorado. The 2 airline transport pilots, 1 flight attendant, and 24 passengers were uninjured. The scheduled domestic flight was operating under Title 14 CFR Part 121 on an IFR flight plan. Visual meteorological conditions prevailed for the flight that originated in Dickinson, North Dakota, at approximately 1530.

According to the pilot, he was "following the ramp agent's marshalling signals" while parking the airplane in Zone 4 at DEN. The pilot initiated a right turn as signaled and stopped when he lost sight of the ramp agent. The ramp agent had bent down to move a set of wheel chocks. The ramp agent "came back into [the pilot's] view after a few seconds and gave [him] the command to continue [his] right turn." Once the turn was initiated, it "became difficult to move [the airplane] without having to use more power than should be required." The pilot stopped the airplane and, upon exiting, discovered that the airplane had come in contact with one of the ramp vehicles."

The tug operator stated he had observed the airplane stop and thought it was finished with the parking and ready for service. He positioned the tug and baggage cart behind the airplane to unload baggage. The airplane began to move again and he was unable to move the vehicle before the collision occurred. The ramp agent did not see the tug move in behind the airplane prior to re-initiating the turn.

The airplane's right aft fuselage was crushed inward puncturing the aft cabin pressure bulkhead.

Probable cause

the ground personnel's failure to maintain aircraft/ground vehicle clearance, resulting in the collision. Contributing factors include ground communications not coordinated by the ground personnel and the airport vehicle. The National Transportation Safety Board determined the probable cause of this accident.

Circumstances

Event type
Accident
Highest injury
None
Weather conditions
Visual Meteorological Cond
Light condition
Day
Sky condition
NONE
Ceiling (ft)
0
Visibility (sm)
10
Wind direction
110
Wind speed (kt)
13
Temperature (F)
73
Nearest airport
DENVER INTL
Distance from field
0.0
Airport elevation
5431

Aircraft

RegistrationMakeModelDamageFAR part
N299UX Embraer EMB-120ER SUBS 121

Sequence of events

#OccurrencePhase
1 310 Cruise

Findings

Finding
20200 factor
24526 cause
24621 factor
24021 factor