N317RE Murch Rotec Rally 3 accident

NTSB CHI03LA230 · 2003-07-24 · Searcy, AR · near SRC

Docket — crew, injuries and powerplant

Summary

The experimental amateur-built airplane sustained substantial damage during a forced landing following an in-flight rudder cable failure. The pilot stated, " As I made my turn south (Final) applying right rudder the right rudder cable broke. Because of pressure being applied to both rudder pedals I inadvertently applied left rudder causing the aircraft to go into a death spiral. I applied full right [ailerons] but continued to spiral after three to five rotations I used basic spin recovery and was able to level the aircraft and maintain minimal control at about 250 ft [above ground level]. I landed in an empty lot which was not quite long enough for roll out and came to rest in a ditch ... ." Examination of the failed cable revealed the ends of the separation were frayed.

Full narrative

On July 24, 2003, about 0930 central daylight time, an experimental amateur-built Murch Rotec Rally 3, N317RE, piloted by a private pilot, sustained substantial damage during a forced landing following an in-flight rudder cable failure near Searcy, Arkansas. The personal flight was operating under 14 CFR part 91. Visual meteorological conditions prevailed at the time of the accident. No flight plan was on file. The pilot reported no injuries. The local flight departed from Searcy Municipal Airport, near Searcy, Arkansas, and was maneuvering in the traffic pattern at the time of the accident.

The pilot stated: It was a cool, calm summer morning for July in Arkansas. I departed Searcy Municipal Airport (SRC) at 9:30 AM. The departure was to the south. I made a right hand turn to the west. Remaining in the traffic pattern at 1250 ft [mean sea level] I made a second turn to the right heading north. Just after turning east (base) I heard on my radio that a twin Jet was on its way in for landings at Searcy. I slowed and lingered on base for separation. As I made my turn south (Final) applying right rudder the right rudder cable broke. Because of pressure being applied to both rudder pedals I inadvertently applied left rudder causing the aircraft to go into a death spiral. I applied full right [ailerons] but continued to spiral after three to five rotations I used basic spin recovery and was able to level the aircraft and maintain minimal control at about 250 ft [above ground level]. I landed in an empty lot which was not quite long enough for roll out and came to rest in a ditch ... .

A Federal Aviation Administration inspector examined the rudder cable separation. The cable separation appeared frayed.

Probable cause

The frayed rudder cable that failed during the turn to final. A factor was the ditch the airplane encountered during the forced landing. The National Transportation Safety Board determined the probable cause of this accident.

Circumstances

Event type
Accident
Highest injury
None
Weather conditions
Visual Meteorological Cond
Light condition
Day
Sky condition
NONE
Ceiling (ft)
0
Visibility (sm)
8
Wind direction
170
Wind speed (kt)
4
Temperature (F)
81
Nearest airport
SEARCY MUNI
Distance from field
1.0
Airport elevation
264

Aircraft

RegistrationMakeModelDamageFAR part
N317RE Murch Rotec Rally 3 SUBS 091

Sequence of events

#OccurrencePhase
1 130 Cruise
2 180 Cruise
3 320 Cruise

Findings

Finding
10735 cause
10735 cause
19200 factor