N2973T Piper PA-28-161 accident

NTSB DEN03LA139 · 2003-08-06 · Crowheart, WY

Docket — crew, injuries and powerplant

Summary

The pilot, with his three passengers, was climbing through 9,500 feet to fly over a mountain. He said that he encountered a severe downdraft and was unable to clear the mountain peak. He made a forced landing straight ahead, "for fear of a stall or spin into the trees." The airplane slid approximately 100 feet, separating the fixed landing gear and crushing inward the fuselage bottom. The density altitude at the accident location, an altitude of 8,795 feet, was calculated to be 11,955 feet. The density altitude at 9,500 feet was calculated to be 12,825 feet. The airplane manufacturer's representative said that "published engine performance charts indicate that the airplane had exceeded its certificated limitations." A postaccident engine test run was performed, and no anomalies were identified.

Full narrative

On August 6, 2003, at 1350 mountain daylight time, a Piper PA-28-161, N2973T was substantially damaged when it collided with terrain during a forced landing 6 miles west of Crowheart, Wyoming. The private pilot and his three passengers were not injured. Visual meteorological conditions prevailed. A VFR flight plan had been filed for the cross-country flight being conducted under the provisions of Title 14 CFR Part 91. The flight departed Riverton, Wyoming, at 1320.

According to the pilot, he was en route to Jackson Hole, and was climbing through 9,500 feet to fly over a mountain. He said that he encountered a severe downdraft and was unable to clear the mountain peak. The pilot made a forced landing straight ahead, "for fear of a stall or spin into the trees." The airplane slid approximately 100 feet. The left and right main landing gear, and the nose landing gear were sheared off. The bottom of the fuselage was crushed inward and torn.

The density altitude at the accident location, an altitude of 8,795 feet, was calculated to be 11,955 feet. The density altitude at 9,500 feet was calculated to be 12,825 feet. The airplane manufacturer's representative said, "Published engine performance charts indicate that the airplane had exceeded its certificated limitations."

On November 30, 2003, the pilot contacted the National Transportation Safety Board through a public correspondence. He stated that he "failed to include in [his] narrative that the engine was skipping during the flight." On January 14, 2003, the engine was run at Beelges Aircraft Company in Greeley, Colorado. The mixture control had been crushed during the impact sequence, and could not be adjusted; the other engine controls were fully functional. During the test run, the engine obtained 2,250 rpm. The magnetos were checked, and the right magneto showed a loss of 50 rpm and the left magneto showed a loss of 75 rpm. A maximum allowable rpm drop during a magneto check is 150 rpm, provided both magnetos are within 75 rpm.

Probable cause

The pilot's inadequate preflight planning (attempting to exceed aircraft's published certificated performance), the pilot not obtaining sufficient altitude to clear the terrain (not possible), and the pilot's inadequate in flight planning/decision making. Contributing factors were the high-density weather conditions, the downdraft weather conditions, and the mountainous terrain condition. The National Transportation Safety Board determined the probable cause of this accident.

Circumstances

Event type
Accident
Highest injury
None
Weather conditions
Visual Meteorological Cond
Light condition
Day
Sky condition
NONE
Ceiling (ft)
0
Visibility (sm)
10
Wind direction
0
Wind speed (kt)
4
Temperature (F)
79
Distance from field
46.0
Airport elevation
5525

Aircraft

RegistrationMakeModelDamageFAR part
N2973T Piper PA-28-161 SUBS 091

Sequence of events

#OccurrencePhase
1 240 Cruise
2 230 Cruise

Findings

Finding
20000 factor
20000 factor
17300
24001 factor
24010
19200 factor
19200 factor