N51852 Texas Helicopter OH-13E-M74 accident

NTSB LAX03CA250 · 2003-07-30 · Tulare, CA

Docket — crew, injuries and powerplant

Summary

The helicopter collided with power lines during an aerial application. The pilot was on his nineteenth pass over the field, traveling eastbound. Power lines were located on the east and west side of the road. There was a pole about 75 feet tall, and the top 6 feet contained three wires. The top wire, a black colored insulator wire, was located 3 feet from the top of the pole. The pilot located the outbox on the pole and determined he would fly above the box to clear all of the wires. As he flew over the lines, the helicopter impacted the insulator wire about 1/2 foot above the cockpit floor. The helicopter slid along the wire and then the wire broke from the insulator at the next pole. The poles were placed about 300 feet apart. As the helicopter impacted the ground, the left skid hit first, followed by the main rotor.

Full narrative

On July 30, 2003, at 0720 Pacific daylight time, a Texas Helicopter Corporation OH-13E/M74 WASP, N51852, collided with power lines during an aerial application near Tulare, California. The pilot was operating the helicopter under the provisions of 14 CFR Part 137. The commercial pilot was not injured; the helicopter sustained substantial damage. Visual meteorological conditions existed during the flight and no flight plan had been filed. The flight departed from the local area about 0600.

A Federal Aviation Administration (FAA) inspector reported that the pilot was on his nineteenth pass over the field, traveling eastbound. Power lines were located on the east and west side of the field. The power lines were attached to poles about 75 feet tall, and the top 6 feet of each pole contained three wires. The top wire, a black colored insulator wire, was located 3 feet from the top of the pole. The pilot located the outbox on the pole and determined he would fly above the box to clear all of the wires. As he flew over the lines, the helicopter impacted the insulator wire about 1/2 foot above the cockpit floor. The helicopter slid along the wire and then the wire broke from the insulator at the next pole. The poles were about 300 feet apart. As the helicopter impacted the ground, the left skid hit first, followed by the main rotor.

In a written report, the pilot stated that "paying more attention" would prevent future accidents.

Probable cause

the pilot's failure to maintain clearance with the wires due to an inadequate visual lookout. The National Transportation Safety Board determined the probable cause of this accident.

Circumstances

Event type
Accident
Highest injury
Minor
Weather conditions
Visual Meteorological Cond
Light condition
Day
Ceiling (ft)
0
Visibility (sm)
5
Wind direction
360
Wind speed (kt)
3
Temperature (F)
63
Distance from field
0.0

Aircraft

RegistrationMakeModelDamageFAR part
N51852 Texas Helicopter OH-13E-M74 SUBS 137

Sequence of events

#OccurrencePhase
1 220 Cruise
2 230 Cruise

Findings

Finding
20200
24021 cause
24526 cause
19200