N51FY accident

NTSB NYC00LA156 · 2000-06-09 · FORTY FORT, PA · near WBW

Docket — crew, injuries and powerplant

Summary

During takeoff, approximately 150 above the ground, the propeller reduction gearbox input shaft failed, and the airplane lost all power. The pilot performed a forced landing to a field where the airplane struck a fence. After reviewing the wreckage, the pilot stated that he machined his own shaft for the home built airplane. He stated that he machined the shaft too thin, and after about 150 hours of operation, it failed at its weakest point. The kit manufacturer stated that the production model shafts are larger, and used aviation splines, whereas the accident airplane had a smaller shaft that used automotive splines.

Full narrative

On June 9, 2000, about 0850 Eastern Daylight Time, a homebuilt S-51, N51FY, was substantially damaged a force landing to a field at Forty Fort, Pennsylvania. The airplane departed from Wilkes-Barre Wyoming Valley Airport (WBW), Wilkes-Barre, Pennsylvania. The certificated commercial pilot sustained minor injuries. Visual meteorological conditions prevailed, and no flight plan was filed for the local personal flight conducted under 14 CFR Part 91.

The pilot stated that during the initial climb, about 150 feet above the ground, the engine lost all power. The pilot performed a forced landing to a field. During the landing, the airplane struck a fence and sustained damage to the right wing.

Examination of the wreckage by a Federal Aviation Administration inspector revealed that the propeller reduction gear box input shaft had sheared.

When asked about the shaft, the pilot stated that it failed "at the weakest point." He added that the failed area was too thin, and needed to be re-machined. He believed that over an approximate 150 hours of operation, stress caused the component to fail.

According to the kit manufacturers, the failure was limited to the pilot's airplane. A machine shop had provided the reduction gearbox input shaft for the production models. The pilot decided to machine his own parts for his particular airplane. The pilot obtained some rough castings from the machine shop, but that was the only similarity between the failed shaft and the production shafts. The manufacturer added that the shafts in the production models are larger, and use aviation splines, whereas the pilot used automotive splines.

Probable cause

The owner/builder's inadequate design, resulting in total failure of the reduction gear assembly accessory drive shaft. The National Transportation Safety Board determined the probable cause of this accident.

Circumstances

Event type
Accident
Highest injury
Minor
Weather conditions
Visual Meteorological Cond
Light condition
Day
Sky condition
NONE
Ceiling (ft)
0
Visibility (sm)
10
Wind direction
220
Wind speed (kt)
10
Temperature (F)
73
Nearest airport
WYOMING VALLEY AIRPORT
Distance from field
0.0
Airport elevation
545

Aircraft

RegistrationMakeModelDamageFAR part
N51FY — — SUBS 091

Sequence of events

#OccurrencePhase
1 351 Cruise
2 180 Cruise
3 220 Cruise

Findings

Finding
15605 cause
82000 cause
20200