N495WP WSK PZL Mielec M-18A accident

NTSB SEA04TA147 · 2004-07-26 · Burns, OR

Docket — crew, injuries and powerplant

Summary

The pilot was attempting to climb following a fire retardant drop. When he moved the throttle forward, the engine did not respond. The airplane started loosing altitude, and the pilot performed a forced landing to an open plateau. During the landing, the throttle would not retard all the way. In order to land the airplane, the pilot turned the fuel selector to the off position. During the landing roll, the left wing impacted a fence pole bending ribs and wrinkling the aileron. Post accident examination revealed that the bolt normally connecting the throttle linkage clevis to the throttle arm was missing. The investigating team examined a sister aircraft from the same provider. They found that a nylon lock nut had been installed on the clevis bolt, and it was loose enough to be removed without the aid of any tools. The industry standard, found in FAA Advisory Circular AC43.13-1B, chapter 7, section 4, paragraph 7-64, states that nylon locking nuts should not be used with rotating components or assemblies. It further states that nylon and/or fiber nuts are highly susceptible to wear from repetitive use and from high heat applications.

Full narrative

On July 26, 2004, at 1326 Pacific daylight time, a WSK PZL Mielec M-18A [Dromader], N495WP, was substantially damaged when it struck a fence post during a forced landing attempt near Burns, Oregon. The commercial pilot was not injured. Western Pilot Service Inc., Maricopa, Arizona, was operating the aircraft for the United States Department of Agriculture, United States Forest Service. Visual meteorological conditions prevailed for the fire retardant application flight that originated approximately 20 minutes before the accident. A company VFR flight plan was on file.

The pilot reported that he was attempting to climb following a retardant drop. When he moved the throttle forward, the engine did not respond. He said the airplane started loosing altitude, and pumping the throttle had no effect. The pilot saw a plateau just southwest of the fire, and he performed a forced landing to it. During the landing, the throttle would not retard all the way. In order to land the airplane where he wanted to, he turned the fuel selector to the off position. During the landing roll, the left wing impacted a fence pole bending ribs and wrinkling the aileron.

Post accident examination revealed that the bolt normally connecting the throttle linkage clevis to the throttle arm was missing. The investigating team examined a sister aircraft from the same provider. They found that a nylon lock nut had been installed on the clevis bolt, and it was loose enough to be removed without the aid of any tools. The industry standard, found in FAA Advisory Circular AC43.13-1B, chapter 7, section 4, paragraph 7-64 states that nylon locking nuts should not be used with rotating components or assemblies. It further states that nylon and/or fiber nuts are highly susceptible to wear from repetitive use and from high heat applications.

Probable cause

The improper installation of the throttle linkage clevis to the throttle control arm by unknown maintenance personnel. Contributing factors were the nylon lock nut separating from its' bolt, which permitted the throttle cable to disconnect from the throttle control arm, and the fence post. The National Transportation Safety Board determined the probable cause of this accident.

Circumstances

Event type
Accident
Highest injury
None
Weather conditions
Visual Meteorological Cond
Light condition
Day
Sky condition
NONE
Ceiling (ft)
0
Visibility (sm)
10
Wind direction
0
Wind speed (kt)
4
Temperature (F)
88
Distance from field
0.0

Aircraft

RegistrationMakeModelDamageFAR part
N495WP WSK PZL Mielec M-18A SUBS 137

Sequence of events

#OccurrencePhase
1 130 Cruise
2 352 Cruise
3 180 Cruise
4 310 Cruise

Findings

Finding
16004 factor
24111 cause
20200 factor