N172WW Cessna 172M accident

NTSB NYC04LA211 · 2004-09-10 · Medina, OH · near 1G5

Docket — crew, injuries and powerplant

Summary

During the takeoff roll, as the pilot rotated at 60 knots, he felt the airplane was "slow to lift," and aborted the takeoff. He reduced the power to idle and applied the brakes; however, the airplane traveled off the end of the runway, impacted a fence, and nosed over in a ditch. Examination of the Lycoming engine revealed low compression in the number 3 cylinder, due to a fractured cylinder ring. The last 100-hour inspection was performed approximately 3 weeks prior to the accident, and the airplane had flown 1 hour since then. The entry for the inspection revealed a compression check of the number 3 cylinder resulted in a reading of 55/80 psi. According to 14 CFR Part 43 Appendix D, "Each person shall inspect components of the engine and nacelle as follows...Internal engine - for cylinder compression...If there is a weak cylinder compression, [inspect] for improper internal condition and improper internal tolerances." Lycoming Service Instruction No. 1191A, stated in part, "Pressure readings for all cylinders should be nearly equal...a difference of 10 to 15 psi indicates an investigation should be made...if the pressure reading for cylinders is below 60 psi...removal and overhaul of the cylinders should be considered."

Full narrative

On September 10, 2004, at 1150 eastern daylight time, N172WW, a Cessna 172M, was substantially damaged during an aborted takeoff at the Medina Municipal Airport (1G5), Medina, Ohio. The certificated private pilot was not injured. Visual meteorological conditions prevailed for the local personal flight conducted under 14 CFR Part 91.

According to the pilot, the purpose of the flight was to perform three takeoffs and landings to maintain his 90-day currency to carry passengers. He completed three takeoffs and landings from runway 01 without incident, and then decided to perform one more. During the fourth takeoff, as the pilot rotated at 60 knots, he felt the airplane was "slow to lift." The pilot decided the airplane would not make it over the roadway and wires at the end of the runway, and he aborted the takeoff. He reduced the power to idle, applied the brakes, and used 40 degrees of flaps; however, the airplane traveled off the end of the runway, impacted a fence, and nosed over in a ditch.

A witness, who was on the taxiway located at the departure end of runway 01, heard a change of engine power during the airplane's takeoff roll, followed by the sound of tires "squelling on the pavement." He then observed the airplane travel off the end of runway 01 and impact a fence.

Examination of the Lycoming engine by a Federal Aviation Administration (FAA) inspector, after the accident, revealed low compression (34/80) in the number 3 cylinder. The cylinder was then removed from the engine and further examination revealed that a cylinder ring was fractured.

According to the engine logbook, the last 100-hour inspection was performed on August 20, 2004. The entry for the inspection revealed a compression check of the number 3 cylinder resulted in a reading of 55/80 psi. The number 1, 2, and 4 compression check values were 66/80, 70/80, and 62/80, respectively.

The airplane had flown approximately 1 hour since the annual inspection.

According to 14 CFR Part 43 Appendix D, Scope and Detail of Items to be Included in Annual and 100-hour Inspections, "Each person shall inspect components of the engine and nacelle as follows...Internal engine - for cylinder compression...If there is a weak cylinder compression, [inspect] for improper internal condition and improper internal tolerances."

Lycoming Service Instruction No. 1191A, Cylinder Compression, stated in part, "Pressure readings for all cylinders should be nearly equal...a difference of 10 to 15 psi indicates an investigation should be made...if the pressure reading for cylinders is below 60 psi...removal and overhaul of the cylinders should be considered."

Probable cause

The partial loss of engine power due to inadequate maintenance and by failure to comply with service instruction for low engine compression. The National Transportation Safety Board determined the probable cause of this accident.

Circumstances

Event type
Accident
Highest injury
None
Weather conditions
Visual Meteorological Cond
Light condition
Day
Sky condition
NONE
Ceiling (ft)
0
Visibility (sm)
10
Wind direction
30
Wind speed (kt)
5
Temperature (F)
70
Nearest airport
Medina Municipal Airport
Distance from field
0.0
Airport elevation
1190

Aircraft

RegistrationMakeModelDamageFAR part
N172WW Cessna 172M SUBS 091

Sequence of events

#OccurrencePhase
1 352 Cruise
2 340 Cruise
3 310 Cruise
4 300 Cruise

Findings

Finding
14007 cause
24100 cause
24119
20200