N113AW Bellanca 7GCBC accident

NTSB DEN05LA150 · 2005-09-30 · Longmont, CO · near 2V2

Docket — crew, injuries and powerplant

Summary

According to the flight instructor, during the landing roll the student attempted to correct the airplane from drifting to the right by applying left rudder. The rudder input was unresponsive and the airplane continued to drift to the right and departed the runway. The airplane looped to the right and came to rest on the right side of runway, causing substantial damage. Examination of the airplane revealed the left rudder cable failed. Detailed optical examination of the fractured individual wire ends and strands adjacent to the fracture revealed significant wear damage. Examination of the left side of the fuselage at the cable separation point revealed wear marks on the upper, outboard seatback support bar. The seat was removed from the airplane revealing the seat frame had been repaired on the left side. The weld extended the seatback support bar down and aft, preventing it from lining up with the lower seat support bar. This extension entered the travel path of the left rudder cable. An examination of the remaining airplane systems revealed no anomalies.

Full narrative

On September 30, 2005, approximately 1130 mountain daylight time, a Bellanca 7GCBC, N113AW, piloted by a private pilot, was substantially damaged when it impacted terrain during the landing roll at Vance Brand Airport (2V2), Longmont, Colorado. Visual meteorological conditions prevailed at the time of the accident. The instructional flight was being conducted under the provisions of Title 14 CFR Part 91 without a flight plan. The private pilot and airline transport certificated flight instructor reported no injuries. The local flight departed approximately 1100.

According to the Pilot/Operator Aircraft Accident Report Form submitted by the flight instructor, he and his student were performing touch-and-go landings on runway 26. The instructor stated the last landing was planned as a full stop. He stated that the touch down was good and the airplane was aligned with the runway. During the landing roll, the student attempted to correct the airplane from drifting to the right by applying left rudder. The rudder input was unresponsive and the airplane continued to drift to the right and departed the runway. The airplane looped to the right and came to rest on the right side of runway 26. The left main wing spar was broken, the left landing gear strut was bent aft, and the left rudder cable had separated at its midspan.

Two pieces of the left rudder cable with the mating sides of the fracture were sent to the NTSB, Office of Research and Engineering, Materials Laboratory Division, for further examination. Detailed optical examination of the fractured individual wire ends and strands adjacent to the fracture revealed significant wear damage. Many of the individual wires were worn to a knife-edge adjacent to the fracture. Wear had penetrated to the center portion of the center strand.

Examination of the left side of the fuselage at the cable separation point, conducted by NTSB and FAA, revealed wear marks on the upper, outboard seatback support bar. The seat was removed from the airplane which revealed the seat frame had been repaired on the left side. The weld extended the seatback support bar down and aft, preventing it from lining up with the lower seat support bar. This extension entered the travel path of the left rudder cable. The airplane logbooks contained no entry regarding the maintenance performed on the seat frame. Neither the flight instructor nor airplane mechanic could recall the seat maintenance being performed within the last 2 years. An examination of the remaining airplane systems revealed no anomalies.

Probable cause

the failure of the left rudder cable resulting in a loss of directional control by the pilot. Contributing to the accident was the improper repair procedures on the seat frame. The National Transportation Safety Board determined the probable cause of this accident.

Circumstances

Event type
Accident
Highest injury
None
Weather conditions
Visual Meteorological Cond
Light condition
Day
Sky condition
NONE
Ceiling (ft)
0
Visibility (sm)
10
Wind direction
30
Wind speed (kt)
4
Temperature (F)
75
Nearest airport
VANCE BRAND
Distance from field
1.0
Airport elevation
5052

Aircraft

RegistrationMakeModelDamageFAR part
N113AW Bellanca 7GCBC SUBS 091

Sequence of events

#OccurrencePhase
1 130 Cruise
2 260 Cruise
3 320 Cruise

Findings

Finding
10735 cause
24101 factor
24118
24539 cause
19200