N7810N Piper PA-28-180 accident

NTSB CHI06CA098 · 2006-03-07 · Holly, MI

Docket — crew, injuries and powerplant

Summary

The airplane contacted a guard rail and a ditch during a forced landing on an interstate highway following a total loss of engine power. The pilot reported he initially flew past his intended destination airport and was turning back to the airport when loss of power occurred. He stated they were at 3,000 feet mean sea level (msl) when the engine started to sputter intermittently. He reported that he immediately checked the engine gauges which looked normal, and he switched fuel tanks. The pilot reported that upon reaching an altitude of about 2,000 msl, the engine stopped producing power. The pilot reported he applied carburetor heat and since he had the mixture leaned, he moved the mixture control to full rich. The pilot stated that he attempted to restart the engine to no avail. The pilot reported his choices of a place to land included a small field, a gravel pit, or the highway. He chose the highway. He reported that he intentionally kept his speed between 75 and 80 miles per hour during the landing to match the speed of the traffic on the highway. The pilot reported that during the landing the airplane bounced and contacted a guard rail. The airplane then spun around and contacted a ditch prior to coming to rest. Following the accident the airplane was secured on a flat bed trailer and an engine test run was conducted using an alternate fuel supply. The engine started and ran smooth up to 1,900 rpm. No mechanical failure/malfunction was found which would have resulted in the loss of engine power.

Full narrative

The airplane contacted a guard rail and a ditch during a forced landing on an interstate highway following a total loss of engine power. The pilot reported he initially flew past his intended destination airport and was turning back to the airport when loss of power occurred. He stated they were at 3,000 feet mean sea level (msl) when the engine started to sputter intermittently. He reported that he immediately checked the engine gauges which looked normal, and he switched fuel tanks. The pilot reported that upon reaching an altitude of about 2,000 msl, the engine stopped producing power. The pilot reported he applied carburetor heat and since he had the mixture leaned, he moved the mixture control to full rich. The pilot stated he attempted to restart the engine to no avail. The pilot reported his choices of a place to land included a small field, a gravel pit, or the highway. He chose the highway. He reported that he intentionally kept his speed between 75 and 80 miles per hour during the landing to match the speed of the traffic on the highway. The pilot reported that during the landing the airplane bounced and contacted a guard rail. The airplane then spun around and contacted a ditch prior to coming to rest. Following the accident the airplane was secured on a flat bed trailer and an engine test run was conducted using an alternate fuel supply. According to the Federal Aviation Administration inspector who over saw the test, the engine started and ran smooth up to 1,900 rpm. No mechanical failure/malfunction was found which would have resulted in the loss of engine power.

Probable cause

A loss of engine power due to undetermined reasons. Factors associated with the accident were the guard rail and the ditch which the airplane contacted during the forced landing. The National Transportation Safety Board determined the probable cause of this accident.

Circumstances

Event type
Accident
Highest injury
None
Weather conditions
Visual Meteorological Cond
Light condition
Day
Sky condition
NONE
Ceiling (ft)
0
Visibility (sm)
10
Wind direction
350
Wind speed (kt)
3
Temperature (F)
43
Distance from field
0.0

Aircraft

RegistrationMakeModelDamageFAR part
N7810N Piper PA-28-180 SUBS 091

Sequence of events

#OccurrencePhase
1 350 Cruise
2 180 Cruise
3 310 Cruise
4 320 Cruise

Findings

Finding
25000 cause
20200 factor
19200 factor