N2447Z General Balloon Corp. AX-6 accident

NTSB LAX07CA094 · 2007-01-21 · San Martin, CA

Docket — crew, injuries and powerplant

Summary

The hot air balloon collided with power lines during cruise flight. The pilot stated while en route to his destination he was unable to arrest a descent and the wind blew the balloon into the power lines. The skirts and suspension cables were scorched as a result of the contact. He applied sufficient heat in the balloon's envelope and the balloon ascended to about 300 feet above ground level (agl). Shortly thereafter, he performed a landing in an open filed without mishap. The pilot reported no mechanical malfunctions or failures with the balloon prior to impact.

Full narrative

The hot air balloon collided with power lines. The pilot stated while en route to his destination he was unable to arrest a descent, as the balloon's burner performance was less then he had expected. The wind blew the balloon into the power lines. The skirts and suspension cables were scorched as a result of the contact. The pilot applied sufficient heat in the balloon's envelope and the balloon ascended to about 300 feet above ground level (agl). Shortly thereafter, he performed a landing in an open filed without mishap. The pilot estimated the winds were between 5 and 6 knots.

The pilot reported that he had amassed a total of 983.3 hours in lighter than air aircraft, of which 28.5 hours were in the same make and model as the accident balloon. He reported that at the time of the accident the temperature was about 40 degrees Fahrenheit. He opined that the cold temperature resulted in a decrease in burner performance due to the fuel cooling and less pressure flowing through the burner unit. The tanks on the accident balloon were not equipped with heating elements, although they are on the type certificate. He thought the accident could have been prevented if he had tank heater to warm the burners, or had Supplemental Type Certificated upgraded burner system.

The pilot additionally reported no mechanical malfunctions or failures with the balloon prior to impact.

Probable cause

The pilot's failure to maintain adequate altitude/clearance from power lines. The National Transportation Safety Board determined the probable cause of this accident.

Circumstances

Event type
Accident
Highest injury
None
Weather conditions
Visual Meteorological Cond
Light condition
Day
Sky condition
NONE
Ceiling (ft)
0
Visibility (sm)
10
Wind direction
300
Wind speed (kt)
6
Temperature (F)
39
Distance from field
0.0

Aircraft

RegistrationMakeModelDamageFAR part
N2447Z General Balloon Corp. AX-6 SUBS 091

Sequence of events

#OccurrencePhase
1 220 Cruise

Findings

Finding
20200
24577 cause