N3010Q Maule MT-7-235 accident

NTSB CHI06LA137 · 2006-05-26 · Flushing, MI · near 3DA

Docket — crew, injuries and powerplant

Summary

The amphibian airplane sustained substantial damage when it nosed over during the landing roll on a soft, grass runway with the landing gear in the down position. The pilot reported he decided to land on the grass runway instead of the available asphalt runway because of favorable winds. The landing was normal until about 150 feet into the landing roll. The pilot reported that the small castoring wheels on the amphibian floats sank into the soft ground, and "caused our plane to pole-vault onto its tail." Inspection of the runway revealed that there was about 3/4 inch of standing water on the runway. The left and right landing gear drag braces and the left and right nose wheel castor housings were sent to the Materials Laboratory at the National Transportation Safety Board for inspection. The metallurgical inspection revealed that the fracture surfaces of the weld between the forward end of the struts, and the castor bodies exhibited deformation consistent with overstress with the nose wheel moving aft relative to the strut.

Full narrative

On May 25, 2006, at 2115 eastern daylight time, an amphibian equipped Maule MT-7-235, N3010Q, sustained substantial damage during landing roll on runway 9 (1,330 feet by 150 feet, grass) at the Dalton Airport (3DA), Flushing, Michigan. The pilot and one passenger were not injured. The 14 Code of Federal Regulations Part 91 personal flight departed Clare Municipal Airport (48D), Clare, Michigan, at 1955. Visual meteorological conditions prevailed at the time of the accident. No flight plan was filed.

The pilot reported that he checked the weather at Flint (FNT), Michigan, located about 6 nautical miles to the southeast. The pilot reported that the Automatic Terminal Information System (ATIS) indicated that the winds were from the east at 7 - 9 knots. The pilot elected to land on runway 9. Runway 18/36 at 3DA is an asphalt runway that is 2,510 feet by 50 feet.

The pilot reported that the landing was normal until about 150 feet into the landing rollout. The pilot reported that the small castoring wheels on the amphibian floats sank into the soft ground and "caused our plane to pole-vault onto its tail." The pilot reported that the inspection of the runway revealed that there was about 3/4 inch of standing water on the runway.

The amphibian airplane was equipped with model BF2750A Baumann floats. The left and right landing gear drag braces and the left and right nose wheel castor housings were sent to the Materials Laboratory at the National Transportation Safety Board for inspection. The metallurgical inspection revealed that the fracture surfaces of the weld between the forward end of the struts and the castor bodies exhibited deformation consistent with overstress with the nose wheel moving aft relative to the strut.

Probable cause

The pilot's selection of unsuitable terrain for landing, which resulted in the collapse of the amphibian float's nose wheels, and a nose over during the landing roll. Factors associated with the accident were the soft grass runway, and the collapse of the nose wheel fittings. The National Transportation Safety Board determined the probable cause of this accident.

Circumstances

Event type
Accident
Highest injury
None
Weather conditions
Visual Meteorological Cond
Light condition
Day
Sky condition
BKN
Ceiling (ft)
110
Visibility (sm)
10
Wind direction
150
Wind speed (kt)
7
Temperature (F)
61
Nearest airport
Dalton
Distance from field
0.0
Airport elevation
733

Aircraft

RegistrationMakeModelDamageFAR part
N3010Q Maule MT-7-235 SUBS 091

Sequence of events

#OccurrencePhase
1 300 Cruise

Findings

Finding
19200 factor
19200
10429 factor
10429
24029 cause