N9392X Cessna 182E accident

NTSB NYC07CA059 · 2007-01-19 · Ashland, VA · near OFP

Docket — crew, injuries and powerplant

Summary

The pilot of the Cessna 182E reported that he was conducting night proficiency takeoffs and landings. The first two takeoffs and landings occurred normally; however, after the third takeoff, just after the airplane had lifted off the runway, the pilot's seat slipped all the way to the rear stops. The pilot then pulled the throttle back to prevent a further climb, and the airplane landed hard on the runway. A subsequent examination of the seat rails, seat rail pinholes, seat adjustment pin and coil spring by a manufacturer's representative and a Federal Aviation Administration (FAA) inspector revealed no anomalies. Airworthiness Directive 87-20-03 R2 had been complied with, and an annual inspection had been performed about 7 months earlier. Another FAA inspector, about the same size of the pilot, subsequently tested the seat locking mechanisms while sitting in the seat. He found that when the seat locking pin was secured in any of the pin holes, he could not move the seat. However, when the seat pin was not securely locked in a hole, with "very little" weight shift, the seat would slide backwards to the rear stops without the pin engaging any of the pinholes.

Full narrative

The pilot of the Cessna 182E reported that he was conducting night proficiency takeoffs and landings. The first two takeoffs and landings occurred normally; however, after the third takeoff, just after the airplane had lifted off the runway, the pilot's seat slipped all the way to the rear stops. The pilot then pulled the throttle back to prevent a further climb, and the airplane landed hard on the runway. A subsequent examination of the seat rails, seat rail pinholes, seat adjustment pin and coil spring by a manufacturer's representative and a Federal Aviation Administration (FAA) inspector revealed no anomalies. Airworthiness Directive 87-20-03 R2 had been complied with, and an annual inspection had been performed about 7 months earlier. Another FAA inspector, about the same size of the pilot, subsequently tested the seat locking mechanisms while sitting in the seat. He found that when the seat locking pin was secured in any of the pin holes, he could not move the seat. However, when the seat pin was not securely locked in a hole, with "very little" weight shift, the seat would slide backwards to the rear stops without the pin engaging any of the pinholes.

Probable cause

The pilot's failure to properly secure the seat locking pin. The National Transportation Safety Board determined the probable cause of this accident.

Circumstances

Event type
Accident
Highest injury
None
Weather conditions
Visual Meteorological Cond
Light condition
Night
Ceiling (ft)
0
Wind direction
0
Nearest airport
Hanover County
Distance from field
0.0

Aircraft

RegistrationMakeModelDamageFAR part
N9392X Cessna 182E SUBS 091

Sequence of events

#OccurrencePhase
1 130 Cruise
2 200 Cruise

Findings

Finding
10011
24032 cause
19200