N164JS Bell 206B II accident
NTSB SEA07CA200 · 2007-07-16 · Sheep Mountain, MT
Docket — crew, injuries and powerplant
Summary
The helicopter was transporting supplies with a cargo net from one mountain site to another. The sling loads consisted of steel angle iron, which was bagged and secured with velcro, and then placed into the cargo net. After delivering the fourth load, the pilot lifted off with only an empty bag inside the net. The Bell 206B rotorcraft flight manual, in the supplement for external loading, states, "Control movements should be made smoothly and kept to a minimum to prevent oscillation of sling load." According to a witness, as the helicopter departed, the net "floated very close to the propeller [tail rotor], then floated back down." The net, which was attached directly to the helicopter cargo hook without the use of a long line, swung back up again and impacted the tail rotor, cutting the cargo net and releasing the bag. The pilot heard noise and "thumping" sounds, accompanied by vibrations and yawing, and realized that he had a tail rotor strike. The pilot entered an autorotation at "25 miles per hour and 200 feet" above a timbered slope. The pilot selected a small, sloped, clearing as a landing zone, and upon touchdown, the helicopter rolled over, coming to rest on it's right side.
Full narrative
The helicopter was transporting supplies with a cargo net from one mountain site to another. The sling loads consisted of steel angle iron, which was bagged and secured with velcro, and then placed into the cargo net. After delivering the fourth load, the pilot lifted off with only an empty bag inside the net. The Bell 206B rotorcraft flight manual, in the supplement for external loading, states, "Control movements should be made smoothly and kept to a minimum to prevent oscillation of sling load." According to a witness, as the helicopter departed, the net "floated very close to the propeller [tail rotor], then floated back down." The net, which was attached directly to the helicopter cargo hook without the use of a long line, swung back up again and impacted the tail rotor, cutting the cargo net and releasing the bag. The pilot heard noise and "thumping" sounds, accompanied by vibrations and yawing, and realized that he had a tail rotor strike. The pilot entered an autorotation at "25 miles per hour and 200 feet" above a timbered slope. The pilot selected a small, sloped, clearing as a landing zone, and upon touchdown, the helicopter rolled over, coming to rest on it's right side.
Probable cause
The external load net, attached directly to the cargo hook without the use of a long line, oscillated and made contact with the tail rotor system while maneuvering. The National Transportation Safety Board determined the probable cause of this accident.
Circumstances
- Event type
- Accident
- Highest injury
- Minor
- Weather conditions
- Visual Meteorological Cond
- Light condition
- Day
- Sky condition
- NONE
- Ceiling (ft)
- 0
- Visibility (sm)
- 30
- Wind direction
- 0
- Temperature (F)
- 64
- Nearest airport
- Off Airport
- Distance from field
- 0.0
Aircraft
| Registration | Make | Model | Damage | FAR part |
|---|---|---|---|---|
| N164JS | Bell | 206B II | SUBS | 133 |
Sequence of events
| # | Occurrence | Phase |
|---|---|---|
| 1 | 430 | Cruise |
| 2 | 180 | Cruise |
| 3 | 320 | Cruise |
Findings
| Finding | |
|---|---|
| 17505 | cause |
| 24520 | |
| 19200 |