N333ST Better Burn Llc/Startube Div EXEC 162F accident

NTSB WPR09CA198 · 2009-04-16 · Chandler, AZ · near CHD

Docket — crew, injuries and powerplant

Summary

The flight instructor said the student was practicing a stable hover at 2 to 3 feet altitude, when the helicopter descended with a slight drift to the right. The student said he made a correction and thought the helicopter might touch the ground and lift up again. When the right skid contacted the taxiway, the right rear skid shoe stuck in the asphalt surface and the aircraft rolled right, pivoting on the right skid. The flight instructor immediately bottomed the collective and pushed the cyclic left; however, the aircraft continued to roll onto its right side. Subsequently, the tail boom was bent up and partially separated, the windscreen structure was broken, the main rotor blades were damaged, and the fuselage was wrinkled. The flight instructor said the helicopter belonged to Rotorway, the kit manufacturer, and was used for factory flight training. The company had equipped the skids with prototype skid shoes approximately 10 inches in length that were flat and extended laterally beyond the skids. When the aircraft touched the ground with lateral movement, the aft right skid shoe dug into the asphalt causing the aircraft to roll right. The flight instructor said that after this accident, the company modified the skid shoe design by rounding the shoes to conform to the landing skids.

Full narrative

The flight instructor said the student was practicing a stable hover at 2 to 3 feet altitude, when they experienced an uncommanded loss of altitude with a slight drift to the right. The student said he made a correction and thought the helicopter might touch the ground and lift up again. When the right skid contacted the taxiway, the right rear skid shoe stuck in the asphalt surface and the aircraft rolled right, pivoting on the right skid. The flight instructor immediately bottomed the collective and pushed the cyclic left; however, the aircraft continued to roll onto its right side. Subsequently, the tail boom was bent up and partially separated, the windscreen structure was broken, the main rotor blades were damaged, and the fuselage was wrinkled.

The flight instructor said the helicopter belonged to the company and had been equipped with “flat” prototype skid shoes approximately 10 inches in length. When the aircraft touched the ground with lateral movement, the edge of the aft right skid shoe dug into the asphalt causing the aircraft to roll right. The flight instructor said that after this accident, the company modified their skid shoe design by rounding the shoes to conform to the landing skids.

Probable cause

The flight instructor's inadequate supervision of the flight and delay in taking remedial action to prevent the helicopter from touching down while drifting. Contributing to the accident was the design of the skid shoes. The National Transportation Safety Board determined the probable cause of this accident.

Circumstances

Event type
Accident
Highest injury
Minor
Weather conditions
Visual Meteorological Cond
Light condition
Day
Sky condition
NONE
Ceiling (ft)
0
Visibility (sm)
30
Wind direction
0
Temperature (F)
52
Nearest airport
Chandler Municipal Arpt
Distance from field
0.0
Airport elevation
1243

Aircraft

RegistrationMakeModelDamageFAR part
N333ST BETTER BURN LLC/STARTUBE DIV EXEC 162F SUBS 091

Sequence of events

#OccurrencePhase
1 Landing-flare/touchdown Dynamic rollover defining Cruise

Findings

Finding
Aircraft-Aircraft systems-Landing gear system-(general)-Design - F cause
Personnel issues-Action/decision-Action-Delayed action-Instructor/check pilot cause
Personnel issues-Psychological-Attention/monitoring-Task monitoring/vigilance-Instructor/check pilot cause