N4119S Diamond DA 40 accident

NTSB GAA19CA582 · 2019-09-28 · Mesa, AZ · near FFZ

Docket — crew, injuries and powerplant

Summary

The pilot reported that, he intended to do touch-and-goes in the local traffic pattern.  While on the downwind leg, the air traffic controller cleared him to land.  During the landing roll, past the halfway point on the runway, he increased the engine power to full to takeoff and told the controller that he was doing a "go-around".  The controller immediately instructed him to exit the runway on to the last taxiway so the pilot "cut the entire power", applied brakes and full right rudder, but the airplane skidded, exited the runway and impacted a concrete barrier.    The airplane sustained substantial damage to the forward, lower fuselage.  The flight safety officer reported that there were no preaccident mechanical failures or malfunctions with the airplane that would have precluded normal operation. The pilot added that he wanted to do touch and goes but did not accurately communicate his intentions to the air traffic controller. 

Full narrative

The pilot reported that, he intended to do touch-and-goes in the local traffic pattern. While on the downwind leg, the air traffic controller cleared him to land. During the landing roll, past the halfway point on the runway, he increased the engine power to full to takeoff and told the controller that he was doing a "go-around". The controller immediately instructed him to exit the runway on to the last taxiway so the pilot "cut the entire power", applied brakes and full right rudder, but the airplane skidded, exited the runway and impacted a concrete barrier.

The airplane sustained substantial damage to the forward, lower fuselage.

The flight safety officer reported that there were no preaccident mechanical failures or malfunctions with the airplane that would have precluded normal operation.

The pilot added that he wanted to do touch and goes but did not accurately communicate his intentions to the air traffic controller.

Probable cause

The pilot's decision to abort a go-around with insufficient runway remaining to safely stop the airplane, which resulted in a loss of control, runway excursion and impact with a concrete barrier. The National Transportation Safety Board determined the probable cause of this accident.

Circumstances

Event type
Accident
Highest injury
None
Weather conditions
Visual Meteorological Cond
Light condition
Day
Sky condition
NONE
Ceiling (ft)
0
Visibility (sm)
10
Wind direction
290
Wind speed (kt)
5
Temperature (F)
84
Nearest airport
Falcon Fld
Distance from field
0.0
Airport elevation
1394

Aircraft

RegistrationMakeModelDamageFAR part
N4119S Diamond DA 40 SUBS 091

Sequence of events

#OccurrencePhase
1 Landing-landing roll Runway excursion defining Cruise
2 Landing-landing roll Loss of control on ground Cruise
3 Landing-landing roll Collision with terr/obj (non-CFIT) Cruise

Findings

Finding
Aircraft-Aircraft oper/perf/capability-Performance/control parameters-Directional control-Not attained/maintained cause
Personnel issues-Task performance-Use of equip/info-Aircraft control-Pilot cause
Personnel issues-Action/decision-Info processing/decision-Decision making/judgment-Pilot cause
Personnel issues-Task performance-Communication (personnel)-Accuracy of communication-Pilot factor